TekonshaP3 BRAKE CONTROL + WIRING HARNESS FOR 94-08 FORD F-150, 94-04 F-250 F-350 F-450 F-550. CONTROLLER + PLUG/PLAY WIRE KIT

Easy to install

This is my second Tekonsha P3. First one was used in my Jeep JK pulling a 2000# utility trailer. I used it for four years with no issues.This one was installed in my F250 truck for towing a 8500# travel trailer. Only used for one trip, but so far it works fine. I really like that it doesn't have the lurch and grabbing sensation at low speeds.Easy installation.

Upgraded from the voyager to this and wow what a difference! So far very happy with it worked very well towing our 33ft travel trailer.

Works SUPER GOOD! Was easy to install, plugged right in to an existing plug underneath the dash on my 1996 F250. Easy to operate and easy to set break amount.

Haven’t installed yet so it might work well but the photo shows the correct pigtail for my truck but when it shows up the only wiring that plugs into the back of the brake controller goes to 4 wires with no sort of plug at all. Had to buy separate hope it gets here soon as I need to tow a trailer for the rest of the week and won’t have any brakes on the trailer. Pretty annoying considering this was so expensive.

Install not bad. Does what it supposed to do.

Took only a few seconds to find the plug under my dash, and plug in the controller for my 2008 Ford F150. Everything is working fine from the start.

Reached up under the dash unplugged the old cable, plugged in the new one, installed the snap in holder in the same place the old one was in, plugged in the P3, unit fired right up, set it for B-8.5 (I pull a Fox Mountain 28 foot RV with a F-350 one ton. looking forward to a 6000 mile trip to GA and back this winter. Recommend the P3.