AUTEX 100psi Pressure Transducer Sensor, 0-100 Psi Pressure Sender 1/8" -27 NPT Oil Pressure Transmitter 316 Stainless Steel with Connector Harness Kit For Oil Fuel Air Water Pressure

This is a good pressure transducer. I installed it in a system to remotely measure water level in a well. It operates every 30 minutes 24-7 and has been installed now for 2-1/2 years. It is reliable and accurate (1/2 psi). Good value.

This has been working great for over a year in a Holley Terminator powered LS swapped Jeep TJ. It verified the previous owner had the wrong pump in it and now the new delco pump is supplying the correct 58 psi! Way cheaper than the Holley version and plugged right in!

Worked with my AEM fuel/oil pressure gauge. I was able to troubleshoot my low fuel pressure with this sensor and my AEM pressure gauge.

It works. I had an Auto Meter 4590 sending unit go bad. This sending unit is plug and play. Threads and connector were exactly the same.

This sensor failed miserably after about 30 hours of use. It was properly assembled and wired up. Worked fine under initial use and then stopped working after giving erratic measurements during the middle of a race. Yay! no oil pressure reading on a brand new motor.... Glad the engine never lost pressure.

I've tried a couple of these sensors for basic water and air pressure monitoring. This is the only one that seems to work and is stable. The other cheaper ones seem inaccurate and the latest cheap one worked with air pressure but immediately failed upon testing water pressure. The internal parts were likely not sealed well. Just spend a couple extra dollars on this one and skip the cheaper units.

I'm using this for data logging oil pressure on a race car. It appears to be of good quality and accurate. Durability remains to be seen. I wired it using the pigtail according to the fitment instructions "Wiring: Red for IN+. Black for GND. Green for OUT" and it is working properly.

Used fuel pressure sensor on my LS swap and Holley ecu and works great!!

Great unit and no leaks so far. Used for an LS3 and reads well

Used on my 93 Mustang as a fuel pressure sender with my Holley Terminator X kit. Easy install, works great, plug and play.

Works great so far on Holley Terminator X for dome pressure. Be sure to calibrate properly 0-.5v 0psi 4.5-5v 100psi.... linear voltage

Port on transducer was wrong and didn't match the listings pics, the included pigtail, nor my existing plug. The plug it came with would not fit in the transducer as the transducer port had extra plastic.

I have used this product so far about 1000 km for pressure. It seems to be working. I would recommend this.