Trend Straight Two Flute Worktop Router Cutter, 1/2 Inch Shank, 12.7mm Cut Diameter & 50.8mm Cut Length, Tungsten Carbide Tipped, BR01X1/2TC

I bought these for cutting and shaping my kitchen worktops made from wood and laminate 40mm thick. Had no problens but never having used a router before was surprised how quickly your router bits can blunt. I cut my worktop joints using a Trend Jig and these Trend router bits cutting a few millimeters depth at a time and found these bits were ok for one joint i.e two sides of a joint. They are however a lot cheaper in price than others available and overall not too expensive. The finish was fine and my worktop joints look great.

Strong sharp and cuts a clean line . Standard fit , you will get a fair few cuts with it before it’s dulls down

Would buy these again. They not bad if you go steady on oak worktop.

Good bit

Great router bit, perfect for kitchen worktops.

This router bit is okay, but the Craft Pro version is much better

Excellent. So far I have done 5 worktop joints (thats 10 cuts) using this and its still sharp. How long will it last?, I dont know but its already lasted longer than the other branded cutter i used to buy. I will buy again as long as the price doesn't go up. The cut is very good too as its still sharp.

Great cutter. I used it to cut my son's worktops. You get around 3 cuts before you need to replace it.

Incompatible avec les défonceuses TREND, il faut acheter un adaptateur, malgré le fait que la fraise fasse 1/2" et que la défonceuse soit aussi compatible avec 1/2" car pour TREND, 1/2" fait 12.7mm dans le cas de la fraise, mais seulement 12mm dans le cas de la défonceuse. Bien entendu, TREND vend un collet de 12.7mm qui coute la coquette somme de 44€. Tout est cher et volontairement rendu incompatible pour vous forcer à acheter encore et toujours des accessoires. Je renvoie donc tout, la fraises, le gabarit pour plan de travail et la défonceuse.