StanceMagic - 2pcs 3mm Hubcentric Wheel Spacers (5x112, 66.6mm Bore, No Lip) Compatible with Audi A4 S4 A5 S5 A6 S6 A7 S7 A8 Quattro B8, 2019+ BMW (G-Chassis), and Mercedes Vehicles - 66.56mm

I replaced rims on a 2005 SLK350 due to a vibration issue with prior non-standard rims and 12mm spacers. Although the wheel company assured me the new rims would absolutely fit without spacers, they did not - they slightly rubbed on the front calipers. This forced me to resort to spacers (again) - by getting these 3mm spacers, I was able to get the rims to clear the calipers by about 2mm and still allow the rim itself to center on the hub - so far, no vibrations. The spacers were very accurate in the hole spacing and the center hub hole (fit snugly on the hub - also, I measured the hole with a digital caliper and it was spot on). Thanks for solving a problem created by other's misinformation.

Fits front 66mm hubs that are too long for stepped spacers, such as the Mercedes R230

Ended up not being when I needed but for the money great quality product

Installed the 5mm spacer on a 2014 Audi A4 with aftermarket wheels to get a more flush fit. The 5mm is the max thickness you want to use on this car to keep enough hub exposed for the tire centering, Anything larger requires a Hubcentric spacer.Make sure you order longer wheel bolts which I did order from the same seller. No vibrations noticed. Easy install, much cheaper than other "performance brands". I am actually Using the 3mm on the front and 5mm in the rear. Quite happy with the product and the look I achieved with it and the huge cost savings.

Worked out perfect!! Good quality parts..

Fits like it should. A little loose at the center hub.

Slightly loose fit around the center bore but they are so thin I do not think it matters. I needed the 3mm because my aftermarket wheels already had additional offset and were a half inch wider then stock. I wasn't look to protrude past the fenders, just a little more flush. They did the job but it bugs me I had to fiddle around and try to keep them centered when putting the wheel back on. Believe it or not the wheel offset and width plus this 3mm spacer just cleared the breaks and pushed the wheel out just under an inch.

Good fit. 🙂