Muzata 2M LED Channel System with Milky White Cover Lens, Silver Aluminum Extrusion Profile Housing Diffuser Track for Strip Tape Light 10PACK 6.6FT U Shape U2SW,Series LU1

I bought this so I can run an LED light underneath my couch to illuminate the floor at night. The package that came in was damaged. The three of the pieces are damaged. As for the actual functionality they're nice it does diffuse the LED light. They work good.my biggest complaint would be that when you are running to pieces there's no way to connect them together they have to loose leaf it. They don't stay together wellthe clips are pretty much pointless they sent with you. I am writing a review on the product itself.

Somehow I missed that this doesn’t work at all with the light strip plus. Apparently it only works with 1st gen strips. They don’t even make a 45 degree mounting bracket for the new ones. Not sure why.

I purchased this corner channel for use in LED strip lighting a built-in book/display case. This product is inexpensive, & acceptable for what it is. It arrived well packaged, & the diffuser lenses have protective film over them. However, my install required cutting the channel to 16" lengths, & I quickly realized that the channel thickness was an issue. While the aluminum cuts easily, the cut edges distorted quite a bit. As the installation required a high quality appearance, I ordered corner channel from another Amazon supplier in search of a more robust product. It was apparent out of the box that the second source used a thicker gauge aluminum. To my pleasure, it cut easily with no distortion. To verify, I took 10 measurements of several pieces of each supplier's channel using a caliper, & averaged the results. FYI- Average thickness of this channel (Muzata) = 0.49mm. Average thickness of alternate channel = 0.98mm.

It took some experimenting and ordering the 3 foot(ish) ones to find the right one but these are great. I have ordered quite a few of them and have been pleased with them all.

The right angle extrusion works in corners and emits a highly diffuse light without glare or shadows. It works with all standard adhesive backed LED strips up to 10mm wide. I used them for garage fill lighting and also as closet and pantry lighting with magnetic switches on the doors.I marked it 4 stars instead of 5 because the mounting bracket is a little dodgy and doesn't hold the fixture as securely as I would like.

Package arrived undamaged and the diffuser strips fit nice and snug in the channels. Other listings of similar 45 degree extrusions complained that the diffusers would fall out if turned upside down, so I was happy when these fit great.

The channels are good. I like the quality of the covers. One star off because the plastic clips are useless in my opinion. I drilled directly into the channels and mounted them without the clips.

These channels fill their purpose. The plastic cover fits well, as do the clips. The end caps are a bit tight but can be pushed in most of the way. The mounting is a bit trickier since you have to figure out where the channels go, then hold up the clip to mark your spot, while holding a level (assuming you want a level mounting job), then screw in the clip to the wall.The channels are very light, which makes them easier to work with. I wish the kit included clips that join two segments together. I know they're available but I'd like to have them included.