(2-Pack) 200W 24V Waterproof LED Power Supply Driver Transformer IP67, Adapter 90V-140V AC to 24V DC for LED Light, Computer Project, Outdoor Lighting

Very good product

I intended to use this as a power supply for a diesel heater with a battery backup. It works, but the supply seems to target exactly 12.0 volts under load. I wish it was closer to 12.5 to 12.6V to maintain a charge in a lead acid battery, but that was probably not the intention of the supply so I can't rate it low because of that. Just a note to anyone trying to do the same: It'll power the heater just fine, but the battery will be basically dead at exactly 12V.

The description indicates you get two separate 24v power supplies 100w each. What you get is one power supply with 1- AC input and 2 - 24v outputs on the same unit rated a 200w total.

I use this to power my under the cabinet LED lights in the kitchen. This thing doesn’t even get warm. It has more power than I’ll ever need but wanted something big enough to power additional lights if I ever wanted.

I will write an update after at least one heavy rainfall and confirm if everything is working as expected. I have installed it under desk with covered area; but it can get damp on rainy days.

They only offer a 30 day warranty. I installed one of the 2 units brand new yesterday and it was defective and did not work. The 2 one was fine. I purchased them 34 days ago and they wont allow the replacement. I suggest to anyone who purchases these to plug it in and test it the day you receive them. Lessons learned.

got the 150w version. 2 outputs-- each 6 amps. must connect them to get full power. put a diode on each positive lead cause I'm extra. probably not needed since the voltages match

Calling this a 300 watt source is misleading. Itried to use this to replace another 300 watt circuit of lights, total approx 200 watts, some distance from my home, via a single line of buried 12gauge wire. This device has three power leads, each with 100 watts, so it would not work in a situation like this, and it's unfortunately not clear from anything in the description.If you can arrange your LEDs up into three different runs, then this will work just fine.