aFe Power Dynamic Air Scoop for Dodge Challenger 15-23 V6-3.6L/V8-5.7L/6.4L/6.2L (sc) HEMI

Good product

Does fit a 2019 challenger scat pack with hellcat lower box. It does require about an inch to be shaved off. Basically it pushes the air box right up against the coolant reservoir. You shave enough back to where it can fit over the light cover but doesn’t have tension pushing the right side of the box. After about 3-4 test trials there was a sizeable gap between the box and coolant reservoir and when I felt comfortable I just put some foam tape on the side of the coolant reservoir just in case the box moves from what ever to prevent it from rubbing through

If you have a Challenger that is newer you have to order the short tube that AFE makes. This one will not work as it's too long and pushes the airbox back too far. The short one works perfectly

probably good for a hellcat. it's pretty difficult to modify this thing to fit a scat pack with a hellcat airbox. with this thing installed the airbox pushes up against the coolant reservoir making it impossible for either the airbox or coolant reservoir to sit properly, it's just too long. maybe a hellcat coolant reservoir would fix this issue. i tried cutting the part to fit, but the bend makes it basically impossible to do so while maintaining the correct angle. i'd recommend getting a completely different part, maybe just use generic flexible hose or a rubber headlight intake tube. i ended up just modifying an OEM tube and the bottom intake of the airbox doesn't seal against the hole at the bottom of the engine bay as intended. eventually i'll replace it with generic tubing.

I bought the AFE headlight air scoop for my 2017 Challenger SXT and it was a well spent 46 bucks. I installed it today and It does give the car a great improvement when accelerating. It doesn’t turn the SXT into a hellcat but it does make it go faster. I also noticed the sound is like a hellcats rumble when taking off or making shifts but 90% quieter. It’s like I’m starting to awaken the inner hellcat out of my sxt. Next purchase will be the AFE Cold air intake!!

This thing was a b#*#% to put on and quickly realized it was the wrong part for my scat It didn’t fit out the box. There’s a shorter one you can use so don’t buy this one for a scat it won’t fit unless you modify it.

Easily installed on my Cold Air Intake box, since it's from AFE too. I have a 2012 Challenger with VLAND headlights, with the removable air intake cap. I did have to cut off the ballast mount on the bottom of the left headlight housing to make room for this, but that's not an issue with this product.

This is a fantastic product; however, this is too short for the 2015-2017 models and barely fits on my headlight. As well, for $55 it could have come with a bigger locking tab instead of the small streamline design they were going for. aFe makes fantastic products, but a little R&D could have found out that they 2015-2017 models need a little bit more length to properly fit and designed a secondary tube accordingly.

Llegó muy rápido y no hubo problemas con la instalación

Any air box that has the circular cutout will work with this. And very easy to install and with an added bonus to keeping everything else clean surrounding your airbox

Fits perfect on Hellcat air box. No modifications needed. Better built than the overpriced factory one, that's made out of a thin plastic felt covered thing. The inside of the AFE unit is smooth which should cause for smooth non turbulent air flow. Great upgrade for Hellcat or for the air box mod on a Challenger 3.6, 5.7 and 6.4L

works good