TAILONZ PNEUMATIC 1/4 Inch NPT 24V 2 Position 2 Way Normally Closed Electric Solenoid Air Valve 2v025-08 Outlet Wire

I'm using this as a trigger to run air to a pneumatic drill. For that purpose, it is performing very well. I haven't had to replace it and it's performed well over 200,000 times by now. I expect it might do a million plus cycles similar to other solenoids from this company. Recommended, though your mileage may vary if you have to hold it open for a long time or something like that, might get hot. I wouldn't necessarily think that would be a good idea, but for providing a puff of air, it's great. Total recommend.

Works as advertised with quick cycle time, good for CNC gcode use when supplying compressed air to the cutting tool, less than 250ms delay to open.

As others have mentioned, while it's in the normally closed position it leaks. I have to unhook the compressor when I'm done or it will cycle forever. Other than that, it works as it should on my laser cutter.

This thing is a real hunk of junk. I have used it 6 times and now if failed just under the 25 days.. I would send it back but I don't have the original box it can in.. This is the 3rd piece of equipment I got from them and they were all junk. @ of them were air driers / regulators, both did not work right out of the box...

Works just like you'd expect. Gets a little warm, so we'll see how long it holds up.

It is been in operation for 1 hour and I hope it runs forever.

Worked just as expected. Will purchase again

I bougth this producto to control air flow from a diaphragm air pump to my laser cutter. However, the intake port hole is so small (1.5mm - 1/16") it reduces air flow to almost nothing. The valve works fine, but I just want to wanr people that need large air flow to look for another model. The exhaust port hole is a little larger (2.5 mm - 3/32").