WER 3d Sublimation Silicone Mug Wrap,11oz Cup Clamp Fixture for Transfer Printing Tumblers (3 Pack)

These are easy to attach to the ceramic mugs and easy to remove. They fit snugly and do the job. I use these in my convection oven for sublimating mugs, and these fit well.

Works great. I submlimate my mugs in my convection oven for 12 to 15 minutes at 400 degrees Fahrenheit.Steps:A) Preheat dedicated convection oven to 400°.B) Attach MIRRORED image (I forget to mirror more times than I'd like to admit) with heat tapeC) Attach protective paper layer with tape. (I've been using Kirkland Parchment Non-Stick Paper from Costco, but I hear non-waxed butcher paper is better. )D) Attach mug wrapE) Place in convection oven for 12 to 15 minutes. (If oven stays a solid 400° the entire time, then 12 minutes. Mine drops sometimes all the way down to 350, that's when I leave in it in 15 minutes. It's more of an educated guess, but with the use of a dedicated thermometer inside the convection oven has made it pretty easy to be on the more educated side of that guess.)F) Remove mug using heat resistant gloves and pop open the wrap.G) Carefully remove all layers of paper and set in front of can until cool.That's what has worked for me, hope this helps you too.

These work great. Of course I was the "fool" that didn't realize that I needed blow out paper or else the sub print would go through to the silicone. 🤦‍♀️🤦‍♀️🤦‍♀️

These were easy to use and fit perfectly on the mugs I bought. I am planning on ordering more so I can do more mugs at once.

Works great

Works great! Just be careful when you tighten/ unclamp it . The metal part sometimes scratches the handle area if you are not very careful.

Excellent mug wraps. They do the job and do it very well. If you are having problems, it is not because of the wraps. You need to look at you time and or temp settings. Blurry image is because the temp is too high, faded image is because it didn’t cook long enough or temp too low. Every oven is different and none are

The fitted nicely. However, my mug were chipped near the handles where the clamps lock at..

First time trying where fiddly to fasten them but we’ve made a few cups now deffo would recommend

I have not had any issues with these wraps. They work extremely well. I have made many mugs with them. Just be sure to put a couple layers of paper over they project as the Cricut infusible ink can bleed through and stain the silicone, not that it matters that much as it does not transfer back on to the next mug. I had no issues with closing and opening the wrap. I did not chip any of the many mugs I have made. Just be sure to hold on to the clamp when opening and you will be fine. I would not hesitate to buy again. Great alternative to buying a huge mug press!! These take up hardly any room and are a fraction of the price of a press.

I bought these to use in the convection oven for sublimation of mugs.They ever work great. I'm so happy that I bought these. I now get even prints from edge to the edge. Every time.Not like when I use my mug press.Well worth it in my mind.100% recommended!

I own one and I bought 3 more more. I proceeded doing the cups and the 3 new ones wasn't tight enough for a clear picture. My old wrap worked perfectly.

A good value mug wrap. They work great, I do suspect over time they will stretch like any mug wrap and will need to be replaced. I had one that tore but it was quickly replaced. Great customer service.