HunterValve Diaphragm Assembly for PGV 1 inch - ASV & SRV Valves 332100

Thank you

Be sure to use a PH 2 to loosen screws, not a PH 3. Be sure to re-install bonnet.

Great solution to a leaking valve and multiple zones sticking ON at the same time. BUT... 2x more expensive here on Amazon that at the local Home Depot. Take the drive and buy them there...exactly the same thing. I have Hunter SRV valves and they worked fine. My old diaphragms were totally gunked-up.TIP: easy to install but just make sure to align the little tab/tube seen in the picture off to the side/bottom to the body of the valve. It can get a little sideways or misaligned and leak it you do not. You can take it back apart and try again which is no big deal. Cross-tighten screws evenly.

Servicios de entrega a tiempo y completo. Recomiendo esta forma de compra

Make sure you clean all grooves for the diaphragm to seal well . Easy to install can be a pain to prep to install. Works great.

Great way to repair your irrigation valves, get that water out to the plant that need it! Over time, heat causes the rubber to harden, the diaphram does not open as much restricting the amount of water that will flow through it, this is especially true in Arizona...where the heat sore's up over one hundred degree's for many many months!

I replaced this diaphragm with one which was only a couple of years old. The old one barely leaked but I could hear a slight hiss at the valve so I brought this one and has done the job!

part worked great sprinkler repaired