77402 Plateguard, Tabless License Plate Frame and Holder/Bracket, Chrome

Easy install, nice and clean looking without the tabs. It is chrome plated plastic, but very thick plastic, so it should last a few years at least. The only trouble I had installing was that I needed to use longer stainless screws to attach it to the car, so I had to buy those locally. The Plateguard website says to use 5/8" or longer screws. It also sits away from mounting tabs a little bit, so it appears to sort of float, that keeps it from vibrating or clunking when closing the trunk. Good product, better than most plate covers I've used in the past.

The product says Made in China, I think it should say: Well Made in China.I've looked at many designs in the last 8 months...this one belongs in the Museum of Modern Arts, right next to Dieter Rams for Braun and Herman Miller. contemporary and classic...just enough and not more. Very well done!The cost to produce the tooling just to make this part must have been over $100,000.I liked the design immediately. I messed up when I installed it...I had to modify it. (This is my problem). During my error, I discovered that the copper plating and chrome plating were very generous and well done. I removed the ball radius nobs that contacted the rear of the license plate...and forced the frame away from the car...I did it badly. As I am getting older, I just cannot remember where my good tools are. I used instead a disk sander: not good. When the plating starts to go green, I'll just go on Amazon and get another one.

Awesome look and shows the whole plate. It will be easy to attach tabs.

The license plate seems to be of very high quality and the chromed plastic looks flawless. My favorite thing about the plate frame is that, unlike other frames I've used, it makes no contact with my cars paint. The only reason it didn't give this a five star rating is because I had to put foam tape between the tabs and my Minnesota license plate. Otherwise, the plate would not have fit snugly and there would have been a gap on each side between the plate and the frame.

So far so good I've had This license plate frame for about 3 months And still looks good and is holding up. It is made of plastic but it looks like metal And it's very strong it's not cheaply made either.

I have Nevada United We Stand plates that say "We Will Never Forget" at the bottom. Of course my car only has two screw holes for each plate and every other frame I could find covered the We Will Never Forget part. I looked EVERYWHERE, every Walmart & Target I came across, every auto parts store and on-line, then I came across these. A little more than I wanted to spend but that's OK because they look great. I purchased some screw covers and glued to over the screw holes at the bottom so they would look nice.

This is my 2nd one ordered. The first was for he front and it was great!This one did it fit for the back as its thick in a sense it gets in the the way of the back mirror. Had to return.Though I wish it did fit. It's of good quality, I wish they do a slim version for the back!Thank you

Got it today and installed it today! It looks even better on the car. Very well made. I think that it is plastic, but feels like metal. License tag is completely secure as it screws in with the same 2 or 4 screws that hold the frame on.