Wilson Electronics 100 ft. Black WILSON-400 Ultra Low Loss Coax Cable (N-Male to NMale)

I have never used LMR-400 so I cant really compare to this but this was easy to use and similar to orther RG-8 types I have used (but with better specs). I ruined one of the N connectors and had to replace it. I used a PL-259 and it fit perfectly. Easy enough to strip and work with the shield. This is now feeding a cell phone antenna/amplifier and supports close to the 2Ghz without the horrible line losses you get with smaller cable. High frequencies (400Mhz and up ) and long runs especially require good coax like this and if you dont have it you are giving up most of your signal to your coax. Cell phones use 700Mhz and 1900Mhz.

Use this for my U/V satellite linear polarize antenna. So far no issues, and works great!

We just completed wiring our large manufacturing warehouse and offices with a cell booster system from Wilson Electronics. We used the Ultra Low Loss cable in various lengths, including 100 ft, 50 ft, 30 ft, and 2 ft. It is very sturdy and well made. It was easy to connect to the main and in-line amplifiers and the external and internal antennas. The installation worked without any issues and we now have 5 bars of cell reception throughout our building. Highly recommended. Also, see http://www.amazon.com/gp/product/B009U5C0GI/ref=cm_cd_asin_lnk for more information on the entire system we installed, including how it was connected and the signal loss across each component.

The cable is stiff and not easy to run. Especially if you’re trying to run down wall. The connectors are big so you have to cut a big hole. Especially if you’re running 2-3 down wall to device.

good price good quality would buy again if needed

This stuff is the real deal. Less than 1 dB insertion loss on 100' anywhere in the spectrum I measure. Begins to hit 1 dB loss in the UHF band. Pretty dynamite stuff, esp at 80 cents a foot.

I did not find much data on the "Low Loss" claim but took a chance. I have a Agilent test set that reads loss in db, so I measured the new 100 ft roll after measuring a 3' N-N piece of 3/8" Heliax. The attached photo shows the response 10 mhz to 1000 mhz of the 100' length using the Heliax as a reference. The cable is marked as "Wilson". It does measure as "low loss", and worth the price.

The LMR400 cable is rated at "low loss" - Actually measured about 1.02 dB loss for the 100 foot cable. Pretty good and in spec. I have previously used this outdoors for over a year with pretty good performance. The rigidity of the cable makes this a little difficult to use. Do not create sharp bends in the cable, you must respect a moderate radius if a bend is needed. If you need PL259 connectors, I recommend purchasing good quality adaptors and waterproofing the connection in lieu of attempting to replace the N types connectors. The factory connectors are sealed well and hold up outdoors

I installed this cable for my amateur radio repeater on UHF, flat SWR works great! Connectors are good and well sealed, I will purchase it again for my amateur radio needs.

perfect

Very fast delivery. Product exactly what I wanted. Thanks