Supershieldz (3 Pack) Designed for Lenovo Chromebook Flex 5 (13 inch) Screen Protector, Anti Glare and Anti Fingerprint (Matte) Shield

The protector is a film probably PET type. The package comes with a microfiber cloth but no wipes. The film has sticker on both side. The idea is to peel off one side (Number 1), lay it on top of the device, and then peel off the other side.Installation is quite tricky. It's much harder to apply than a glass one because the protector is flexible. What I would do is to apply some masking tape on the (#2) side to use as a handle. Clean the screen and wash your hand and then use some tape to pull off any dust particle. This part is quite important because you will most likely get some dust. Make sure you wash your hands too. I would then peel off the #1 and then align the protector around the camera hole and line it up along that edge and keep moving it around until it's align before laying the rest down. Be real careful not to bend the screen. It will develop a crimp that will can't be removed. It's more important to make sure that the protector lines up if you use a case, because if the case overlaps with the protector, the protector will lift.Next examine the screen and push out the bubbles with a credit card or finger. Don't remove #2 yet. You may notice that some bubbles can't be removed. This is cause by dust particles. To rid them, get a wad of tape, use another tape to lift the protector and use the tape remove the dust particle. Be sure not to leave a finger print underneath the protector. Usually I end up with several dust particles. Once all of the bubbles are out, Lift the #2 carefully and slowly or you'll end up peeling off your screen protector. You want to do this last since pushing out the bubble will scratch up the protector, but as long as it's protected by #2 peel, it's ok.With the protector in place, you will see that the screen is no longer reflective. As with all film type protector, there is some loss of clarity, but it's not that noticable. You should not be able to notice that there was a screen protector. However, the antiglare does not work in direct sunlight. If you shine a line on it, there will be a glare so the antiglare feature is a bust. However, the matted screen does resist fingerprints. Fingerprints does not show as much.The chief reason I got this was because I needed it to protect against the stylus. In the event there is some dirt, the screen could get scratched up. I wanted to use a film type protector because based on my experience with ipads, a temper glass protector can add wobbles to diagonal lines. Drawing on it using a Penoval USI 702 stylus, there wasn't any noticable wobble and the pen did not leave a trail on the protector. Drawing on it is different than drawing it on smooth glass. It has a drag like writing on paper, but it's definitely not like writing on paper. There is also a rougher feel to the finger when you touch it.All in all, I like the product even if it is not antiglare. It protectors the screen from scratches and fingerprinting. There are 2 more in the package in case it gets scratched up.

The only thing I have against this is that it's hard to install. Difficult to remove bubbles. If you have trouble installing screen protectors on phones and tablets this is even worse. Wasted all three film and none looked clean.

Buen producto, pero compré mal, porque no me fijé en las pulgadas de la pantalla. Mi laptop es de 14 pulgadas.

The screen protectors, 3, inside the package were each sharply creased diagonally near the middle. The creases are about 2 inches in length. The creases were on all three screen protectors though the packaging had no indication it was ever bent, although it seemed as if the tape over the envelope fold seemed as if it had been opened before. The creases caused permanent damage to the screen protectors and could not be smoothed out. They can be seen visibly with the screens light passing through them.

-First, it does provide good anti-glare. It turns the highly reflective Chromebook into a matte finish screen.-Second, Like all of these types of products it is HARD to do a clean install with no bubbles. Dust is your enemy. To minimize dust, what I did was:1) Swept around the house and room2) Vacuumed with a Hepa filter vacuum, then closed all windows.3) Ran a Hepa room air filter next to where I was going to work for 30 mins or so4) Mopped the floors to pick up remaining dust. AND left the floor wet so dust would stick to surfaces5) Did the same with table. - wiped down with wet rag and left table damp-ish.6) Washed hands of course7) followed other recommendations on putting the thing on - see numerous online tutorials.It all definitely helped. I found that the few bubbles I had are barely noticeable when the Chromebook is on. I only see it when the screen is off, so not really a big problem, but it is hard to impossible to do perfectly without dust and bubbles. I mean, as you can see in my technique, I TRIED!As to this specific product for a "Lenovo IdeaPad Flex 5i Chromebook", it is nearly exactly the same size as the screen itself, top to bottom and side to side. The problem with that is you have like a half of a millimeter on all sides, so placement has to be perfect, and of course that is very difficult to do.I sadly found this out after three tries, and tried even cutting two of the edges on the third try to give myself a little room. It is hard to make a clean cut, and the cut sides did not want to lay down great. If you try it, I recommend doing it on your first one (of the three) to decide If you don't cut the protector, you have to lay it down EXACTLY right because if you are 1 millimeter long on any edge the raised edge of the Chromebook doesn't let the screen protector lay flat. I wrote to ScreenShieldz about this and they GENEROUSLY sent me a replacement to try again. ScreenShieldz, If you are reading this Thank you! But also, consider making these slightly smaller so they are easier to fit on the screen. Overall though, great product for minimizing glare. Thank you again!

This doesn't go on the screen well. You cannot get the bubbles out.

It did not come with glass cleaner wipe so I got small particles under the plastic on the first two tries. So, I wasted first two shields. After providing my own glass cleaner wipe, I was able to get a clean install.

This screen protector went on easily & has stayed on. One of them came damaged during packaging but the company quickly took care of it. Only down side is that when using my stylus it leaves marks of all the places I've used it and doesn't come off easily. But the touch screen still works well with the protector on.

Llegaron dañados porque el empaque venía doblado (falta protección); además de los 3 protectores solo uno fue funcional, ya que los otros dos traían el adhesivo en el lado que no correspondía

It fits well. Needed to protect the screen from my toddler.