Partsam 2Pcs 12V RV LED Porch Awning Lights Bar White 30 LED Exterior/Interior Wall Lamps Utility Strip Lights Bar Surface Mount for Trucks Motorhome Caravan Camper Trailer

Works great Easy to install Very bright

These Partsam 8” RV porch lights are a great upgrade to my overland rig. Super easy to install, and the brightness is perfect for lighting up my entry area without being harsh. The IP67 waterproof rating holds up like a champ—rain, dust, and off-road grit haven’t phased them. I’ve got one on each side of my camper rig on my 06 tundra. Great for evening tasks or just kicking back outside at night. If you're building out a van, truck camper, or RV setup, these are a must-have.

Updating my review as the newest order didn't meet expectations........ I ordered a set of the black housing lights to make a solar powered light for a friend but sadly one of the two units would not work, no light at all.....but I had an extra light from my white housing lights, so I was able to swap it out........ Returning them is too much of a pain in this area; so I ate the cost.... Other than that, I still like them. I am using them to light up my yard off of the solar batteries. The beam of light is better than I expected, nice and wide.

Very compact. Not huge lumen output but great cutoff and not much glare. Easy install, the pigtail is offset so thats a little goofy but the rubber gasket makes for a decent drilling template.

Our camper light went out. I am always nervous on replacement parts but this one was plug and play and seems of good quality. No issues since we replaced the old one.

Bright lights, work perfect, although if you when you mount them, you should use a sealant...mine leaked, but after applying sealant, they work great.

Direct size replacement for T@B 400 porch light (69711F from ITC, with its streaking gasket issues), just drilled a new 1/4" hole for the wire position, the mounting screws are the same position. Looks good. See photo comparing old white bezel with the new black one - they are the same size.

Wire should be in the center. Side wire is questionable.

Bought for the inside of a snowmobile trailer. Thought for the size they would be way brighter.

Seems a reasonable quality plastics. Looks like it will be waterproof as it has a rubber foot to seal the back. Colour temp a bit cool but fine (not that really cool temp). Only gripe is wiring has to go through the back. Not designing to feed wires in from a side. Thought still possible, which I did.

Remplace les lumières de type H3 , à l’arrière d’un camper Lance 1172….. Belle éclairage, et meilleur style que les lumières originales…