6 Pack Wall Mounted Pulley 1-1/2 Inch Wall and Ceiling Mount Single Pulley for 3/8" Wire or Rope, Zinc-Plated

These are well made. They have deep enough channels that the line easily stays in them.

Sturdy material. I use them on my sawmill.

I used these to lift windows in place during a remodeling project.

It looks like it’ll work for what I need

As described

Works on ceiling wall floor versitle mount. The removable wheel is awesome when working with wire cable that has loops on the end.

I bought these to move the 6 hand winches for my 5 kayaks and 1 canoe that hang from the ceiling of the garage. 4 or 5 years ago I bought half a dozen from TSC; well made, ball bearings and they work great (and today are over $12 each). The new location the ropes go through a pair of pulleys to lift the watercraft, then to the east wall and turn a corner at the south wall then turn downwards to the winches: originally the ropes just ran along the east top plate and turned down to the winches. These will be used on the new location to redirect downwards while the original ones will redirect at the corner.Typical imported product. Difficult to disassemble and reassemble because the sleeve bearing (was expecting ball bearings- think I confused products) are a tiny bit too long and requires some force in each procedure. They are rated for 420 pounds, N.F.Way, but my application is for 70 pounds or less for each pulley. I hope they will work but I certainly would not trust them anywhere near that 400 pound mark and I’m not confident they would survive 150 pounds. I am marginally satisfied and if they do work well, I’ll saved about $50 over TSC higher quality. Worst case, I’ll lube the axles with graphite

I used this to create a platform that I can lower and raise in my garage. These were perfect for what I needed.