BTF-LIGHTING5PCS 3.28ft 1meter 3 Pin 0.32mm²/22AWG IP65 Extension Cable Wire with Male and Female Connectors at Both Ends for WS2811 WS2812B SK6812 FCOB CCT etc LED Strip 15mm nut Small Size

The 2 pin big size is close, but not compatible for Twinkly Gen II Residential connectors. The provided measurements are compatible, but the cut out on the bottom of the female connector is too small. The male connector fits fine. Looked high quality, just didn't fit my purpose.

My husband and I bought permanent lights for outside of our house. They do not provide any type of extension cords on their site so we have been purchasing and returning cords one after another after another finally, we found the one that was ultimately the proper one and again the pins are further apart on the one we bought then they are on the cord for our lights. Guess my kids don’t get Christmas lights this year.

the cables look like they are are of good quality however they do not fit my light. The plug is the correct size however the pins are not the same thickness.

I have 2 sets of outdoor permanent lights. One for the house and one for the garage. Bought the small 50' govee kit for the garage and didnt come with extensions. As others have stated you have to mod it (VERY MINOR). Just take a hacksaw and go around the end with the nut. Just use the blade by itself and roll the plug while you go back and forth gently and it will fall off. I bought the 3' extensions. A 4" piece of 3/4 heat shrink seals the deal as the the existing nuts dont connect, lol. Anything over 4' and you are rolling the dice on if its gonna work or not. pic of the garage. Red lines are where extensions are, purple is the control box. Its 16ft lights, 16ft lights, 3ft extension, 16ft lights, 3ft extension, 16ft lights on the garage. 2nd Pic Top is the unmodified extension. Bottom shows it modified and connected. Both of the bottom connections should be gone over with heat shrink or you could get by with electrical tape.

Sadly this didn't fit the Govee Outdoor LED RGBIC strips. The Govee power supply has an oddly spaced three pin plug that doesn't align. These did feel solidly constructed, so I feel like they would be good if the fit worked out.

Did not meet expectations this time around as cable gauge and connector did not fit the existing Hampton Bay cable at hand. Thus, could not use.

Thanks to the other reviewer who pointed this out, but the 3 pin small fit perfectly (aside from the threading being on opposite ends) with the Govee Outdoor String Lights RGBIC that I bought and installed without reading the manual. those had a limit of chaining two strings together so I needed a way to extend power and the control box to the third string. I used the heat shrinking tubing tip from the other review along with theses extensions and they saved me from having to take down the lights I spent hours putting up (without reading the manual).

These work with Govee permanent outdoor lights 100ft (non-pro version) read on!!! Pics included.You need the small size. Out of the box they will not work!!!! You just need to make a small mod to this cable to get it to work. And adding shrink sleeves is a must!!! Like mentioned in other posts you need 5/8 in adhesive 3-1 sleeves. I read another review and took a chance. First you need to cut the thread off the male side. Once the pins are exposed you can use the cable. It will take a bit of wiggling to get it to seat, but it will work. Then slide the heat shrink over both connectors and let it hang over about 1/2 in. Heat it up and you’re done.

Bought these for my Christmas light show. Will cut them to make pigtails and connect to the controller and the other half to the LED prop.

Good quality works for what I need 5star