1/4 inch Router Bit Set, 15pcs 6.35mm Shank Tungsten Carbide Tipped Router Bit Set with Wooden Box, Double Flute Wood Milling Saw Cutter, for Handwork and DIY

Very good kit of bits

OK

I recently purchased the Router Tungsten Carbide Milling Set and I am extremely satisfied with its performance and quality. This set is a must-have for any woodworking enthusiast or professional. The set includes a variety of 1/4 inch router bits, each made of high-quality tungsten carbide. These bits are incredibly durable and can withstand heavy use without dulling or chipping. I was impressed with the precision and clean cuts these bits produced, whether I was working with hardwood or softwood. The bits are also easy to install and remove from the router, making it convenient to switch between different cutting styles. Overall, this Router Tungsten Carbide Milling Set is an excellent investment for anyone looking to achieve professional-level results in their woodworking projects.

Lets be honest, these won't last forever, they are too cheap for that but they will get you buy for quick use. Don't trust the bearings though, all of mine failed after 3 to 4 uses. One did not work from the start. (too tight to turn) After several months of use I felt I needed to add something to this. Despite the very fragile bearings the bits themselves cut exceptionally well, I didn't realise how well until I upgraded to a set 5 times more expensive (Bosch £141.00) The Bosch bits were bouncing a bit and kept leaving burn marks. It was the exact same kit bit wise as these. These were much better at cutting but the bearings let them down so I had to use the edge guide.

Excellent value for money, thank you.

The bits work very well and are a good range. Fit my palm router very well and cut very well. The box is nice but cheaply made. Good to see that's where they cut the corners and not on the bits though. I found the inserts were all loose and had to be glued back in. Generally the whole box needing a little attention to make sure it lasted. I didn't mind this but that's why I gave it four stars.

I read quite few reviews saying that these bits break very easily, I didn't have any issues so far. Obviously you can't push too hard with bits of this size, generally speaking you shouldn't cut more than 1/8 inch at the time, TBH I didn't take any chance and went for 3mm at the time... so they are working fine for me

The main bodies of the bits are OK, but the bearings can't take much wear and fail very quickly. (second or third use) The 'non bearing' bits are actually very good, the bearings on the bearing guided bits aren't. I've swapped bearings from another make of worn bits to extend the life..