Universal Jack Stand Rubber Pad Adapter Rubber Slotted Frame Rail Pinch welds Protector Floor Jack Stands for Axle Jack 2 or 3 Tonne

See title. No fault of these, just good to know. Harbor Freight revised the design on the 3-ton Daytona Jack Stands recently and the piston is now wider than it was on the previous revision. These fit the older ones (probably pre March 2023) but they must be "convinced" to fit the new ones. They'll still stretch over the new stands, but I expect the rubber to fatigue and break over time. With a big razor blade and some cut proof gloves, these can be made to fit the new stands. Good luck!

Appears to be pretty good quality. Surprised more vendors don’t make this design. Good for pinch weld undercarriages when doing self service. Problem is when you get your car serviced, they don’t have things and your pinch welds are damaged when they hoist your car.

Worked perfect. Used on 2009 VW Jetta and 2019 Nissan Altima.

Theses Jack Stand Support Pads look well made and seemed to be good quality. The issue I had is that they didn't fit well on my jack stands - I have OTC brand stands. Information about the shape & fit is lacking in the description. My stands seem to have a particularly deep recess/groove for a pinch weld. These pads didn't contact the stands in the center where the most weight would likely be concentrated. They only made contact on about 1/8" on each side, which seemed dangerous. I think they could be useful if you have stands that better fit the bottom of these pads.

These look good and work well. The only issue I have is they don’t fit any of my 3, 4 and 6 ton jack-stands well.

Add a little height to the jack, but good solid protectors. Fit nicely on standard jacks and to not fall off, but easily removed.

Support pad fits well on my standard Husky 3 ton jack stand. Small amount of play but its not going anywhere, as the weight get transferred directly to the jack pad. It also allows for a flat pad, wood, hockey puck, etc. to be used for cars with flat mounts. The material is solid and should last for some time.

These things fit my jackstands snugly so they won’t slip when lowering the vehicle on them and the flange fits well into the groove, holding the vehicle up without damaging it. They also spread the weight a bit, putting less pressure on a single point.