Thermal Pad, 100x100x0.5mm Highly Efficient Thermal Conductivity 12 W/mK, Insulated Heat Resistant High Temperature Resistant Silicone Thermal Pad for IC SSD CPU GPU Heat Sink LED Cooling

Got this for my new Onewheel controller. Hasn't hit 100F since installing it. Seemed a lot more quality product compared to the thinner stock one I was replacing. Easy to cut to fit, and work with in general.

miner was overheating. took it apart and used this to replace the cracked thermal pads. worked very well and reduced temps significantly

Multitude of uses for my repair bench. Good quality, heat transfer, and thickness.

Old 1070 was having thermal issue when playing BL3. Made a big thermalpad fill so the board contacted the backplate through the pad. Also replaced VRM and VRAM thermal pads along the way in the front.The thermal pad came through the mail and there was a big fold mark on the protective films, the pad sandwiched between was unaffected. There were ~1-2mm silicon chipped off near the edge probably due to shipping and handling. Both could be avoided if the pad was shipped with a cardboard inserted and used do-not-bend stickers.

Great seller, good product, great price!

Used on a 3080 ventus 3x 10gb. 2mm thickness. I bought 3 by mistake and ended up with really high temps. turns out, because this pad is really firm, the thickness matters even more. So I got the 2mm, popped them on, and wham, -5c delta from stock. My pads were fine before, but I was doing a complete open, clean, painting shroud, and repaste of the card anyways. excellent value for the price. You could spend double this, and get about 7c less than these with gelid or NB, but for this price, excellent performance

Update:Finally put it to use and it worked as expected. Glass bed held in place on top of the stock bed with this alone—no clips needed. It definitely adds some height (and weight) to the bed, reducing the height you can print. I never printed fast enough for the weight to be a issue. Cleanup was from the glass was easy, so not removing it was never an issue.I eventually went back to the stock bed as materials like to stick to the BuildTak type surface a lot easier and leveling begged for an auto leveler setup. Removal was easy and it slipped back into the original packaging, but a couples corners bent so reusing may require some trimming or some squishing.Speaking of squishing, be careful on initial install to not put too much pressure any one side or bed leveling may not work out as desired.1mm thick may have sufficed for my purposes.Original:Giving five stars based on it coming as expected and well packaged. Though full disclosure as I have not put it to use yet.I bought this to help adhere a borosilicate glass plate to the bed of an Wanhoa i3 Plus (Monoprice branded.) The fit is perfect, and I have high hopes about the thermal transfer to the glass plate.Problem is I am debating losing the simplicity of a removable bed for easy part removal or cleanup, and so I am not totally tied to the idea any longer.That said I still plan to try it out as I’m suspecting thermal transfer may improve or at least the heat be more evenly distributed.I’ll update my review after I confirm.

Half is applied to macbook pro 2018 i9 intel. Bottom plate became very hot then mStand too. Then air cooled. Very satisfied