Vaessen CreativeShrink Art Printable, 5 Sheets, A4, with Shrink Plastic, Glossy Paper, White, 21 x 30 cm

Funciona muy bien. Buena calidad

Worked very nicely with my Canon inkjet printer.Don't forget to lighter then designs before printing (and augment saturation) since it darkens a little bit.It didn't deform too much.Also, easier to cut than the transparent version.

Il prezzo è un po‘ altino ma ottima qualità. Le stampe vengono perfette. Consiglio i fogli bianchi piuttosto che quelli trasparenti perché i colori risultano più vivaci. Ottimo prodotto.

I was quite pleased with this inkjet shrink plastic. I have used other makes of this before but I felt this one was superior when I used it, for one particular reason. It appears to shrink by the same amount both horizontally & vertically, which is an advantage.These inkjet sheets can be difficult & these are the tips I use.To work out the size things will shrink to because each make is different, I take a slim strip (a slim right angle) from the bottom corner of the sheet. I then mark off using a ruler the horizontal & vertical axis. Then I shrink that & I therefore have a gauge to work with.I have found, previously, that if you put a sheet of shrinkjet on top of paper when the printer pulls the sheet through, often it slips & the paper comes through instead. To combat this I remove the paper altogether & just put the inkjet paper in the drawer, then it seems to work fine.Finally colour saturation. On this occasion I didn't mess at all with the colours & the end result was fine for what I wanted. I was shrinking photos to about 3cm or less as a final size. However because the end result is so small it is difficult to see the detail & therefore the colour variation is less evident. Although a very dark photo should either be lightened or probably even better choose a different photo if possible.These sheets are slightly more expensive than other makes but I would use them again if accuracy of size is key.

Après avoir lu qq commentaires inquiétants, c'est avec apprehension que nous avons mis notre création au four.Tout comme le plastique fou classique, le motif se tord et plie dans le four mais se remet vite à plat, encore faut-il attendre comme indiqué sur la notice.Pour que le résultat soit parfaitement plat, sortir du four et, avec du papier sulfurisé dessus et dessous, mettre qqch de lourd dessus et attendre 30 sec. Le résultat est nickel.Fond blanc mais l'impression est nette, très bel effet.Ca coute un cher 15 euros pour 5 feuilles, faut pas se tromper.