DNA MOTORING FL-ZTL-209-CH Front Bumper Fog Light Driver & Passenger Side Enhance visibility [Compatible with 11-14 IS250 IS350 / 10-13 RX350]

Having never even activated my fog lights on my 2011 RX 450H, I noticed glass during a recent car wash and found that my right fog light was shattered. You receive a left and right assembly for $31 compared to the dealer price of $144 for each assembly or $288 for both. Dealer would likely tack on at least $100 to install.My install was very tight. Barely enough room to get a knobby phillips-head where it needed to be. Luckily I have very thin arms. A few You Tube videos showed only one screw was involved, in my case their were 4 for each light. One would have been pretty simple. The two screws behind the windshield washer fluid tank had to be accessed from below the vehicle by loosening the lower panels. You need to be very careful with many of the Lexus fasters as they will easily break if not removed properly.The whole process took me 3 frustrating hours ymmv. In retrospect, I would have taken the parts into an auto body shop for the install and spared a lot of frustration, although I do feel like I accomplished something that was not real easy.The assemblies provided by DNA Motoring were top notch and a direct fit.

I purchased these lights for my husband. I don’t know about men and their cars, but he seemed really excited about them, and he really liked them. He says the price was good and it’s exactly what he wanted. So I’ll give it a good review!

Well, i think they look great and for the money i spent on them, they are surprisingly solid, wellbuilt fog lights. I put them on my 2013 toyota tacoma. Its already prewired so i don't have to worry about running another wire harness kit. I want to keep most of ot factory. It was fairly easy to install after watching a video on YouTube. All i need now is a Toyota relay and switch, which i will order this week and hope they work. If they do or don't i will update my review.

I like the price and the very close design to the actual OEM. The curvature of the lense is accurate. That being said I’m mechanically inclined so I was able to do the modifications needed. The tabs that slide into the actual bumper had to be trimmed with a dremel. I’d buy them again. Quality seems ok thus far. I haven’t hit any major rain yet so I can’t comment on the seal. I put LED’s in and tossed the factory bulb. They are insanely bright.

I have had none of the problems other reviewers note. These fog lamps look great and installed easily. Bulbs are included. I only needed one fog lamp but wanted them to match so purchased both. It remains to be seen if they will be durable. The originals were well pitted from road debris. Consider purchasing some new fasteners for the under engine splash shield before installing the new lamps.

DO NOT BUY! THEY DONT FIT 2014 TACOMA

Worked perfectly, I had bought this light from a different seller and something on the road cracked the glass and broke it, I contacted the other seller to buy just one since I didn't need both and they told me that they only sell the full kit only including the plastic the housing that goes attached to the bumper, bad customer service. And wanted me to pay the $50 I paid the first time. I save money with this one $20 from DNA since it was only the lights that we're been sold and fit perfectly. No complaints. For those of you that say it didn't fit each light has a Left or Right on them pay attention before u say it doesn't fit. It happened to me, they look the same but you have to install them to it's corresponding side. Good thing I was able to figure it out before.

Close the original

Material de plastoco y vidrio, lo que esperaba

These lights fit perfectly and my husband installed them within the hour. It would have cost a ton going to the dealership to get these replaced. The shipping was extremely fast and the packaging solid.

Bought them because of the black lenses, look fantastic was a twenty minute install

Overall seem to be decent quality, didnt have any issue installing really. The height adjustment isnt best and you can only get them half decently accurate. The tiny was darker than expected after reading some said it was lighter than expected.The big issue I have is that one lens has fingerprints on the inside from assembly.. I will never be able to wipe them off so that was a disappointment to see**UPDATE**The next day it rained and I drove for about 20 mins in the rain. That's all it took for moisture to start builing up on the other fog light housing that didnt have finger prints.. There is no reason for a brand new part to leak like this in normal driving conditions, and even worse it happened immediately didnt even last a day. What a complete waste of time and money. I have now tried to contact the manufacturer on this so we will see what happens next.

A little datk compared to OEM but look nice