10mm LED Emitting Diodes Light Lamp Diffused F10 Round for Arduino, ESP32, Raspberry Pi, DIY Electronics Red/Yellow/Blue/Green (Pack of 20pcs) AE1258

Very bright! Work well with my projects.

They're not just for Arduinos... these are ordinary LED's. I used these to build a tally light system for a professional video camera. The LED's are bright, large and easy to see, with good diffusion across the surface. Use Ohm's Law to figure out the resistor value to use with a given voltage. I had some extras... I'll have to figure out something cool to do with them.

We used some of these for a toy traffic light project. Note that the dropping voltage is about 2 volts for the yellow and red and 2.9 volts for green. They make sufficient light at about 15 mA, and top out above 20 mA. The yellow seems to make less light than red, green, and blue, but that was okay for our project. These are not ultra bright, but are sufficient for indicators. Sizes seem consistent, but the flanges aren't very large, so you need to get your holes properly drilled at exactly 10mm diameter.

It's good but most of them were unused as it had many counts

These are fantastic 10mm LEDs! Use them to add a pop of color to your project. Low current requirements (will run at 1ma to 20ma). These are not high brightness, but they are big, and the lens is very cloudy. Perfect for a wide viewing angle and good ambient light spread. Mount these on something that needs to be seen from lots of different angles.

I know about the % difference between, LEDs it is usually a change of maybe .10 give or take a little...BUT not ~.50mm and I know this because i deal with 10mm all the time, the issue is that .10 is a standard, .50 is NOT. Pair this with grossly over sized 10mm beveled holders, that are 10.33 you now are sitting at .80 Almost 1mm around the whole thing so .50mm on each side, of the Holder with this LED, and it doesnt even hold at all.... I never seen this type of grossly undersized LEDs in my life, these in other words are unuseable for the project I am working on. They need to get QC involved really, .50mm or .25 each side is a major thing when using them in a holder.Other than the groosly undersized of the LED, they work, they are bright...so I give them that...just cannot use them or even return them now. Waste of money.

I had wanted larger LED's for a garage parking assistant project; 5mm LEDs were simply to small to be useful. These are perfect for my project. Bright, easy to handle, a good assortment of colors. Highly recommended.

I wish they tell you the voltage limits of these lights. Thoughtbi could replace some eyes on a halloween animatronic.. NOPE