Dorman 902-3038 Engine Coolant Thermostat Housing | Fits Select Jeep Models

Fit perfect and was a direct replacement. Highly recommended this product.

Fit perfectly fella high quality and been working well for over six months

Works great in my 2010 Jeep Wrangler!

Part was delivered on time and it good shape. I wasn’t expecting the plastic to be so thin. You could squeeze it and the plastic bends easily. I hope this isn’t an indication of the quality.

Perfect fit for the wrangler. No need to buy a gasket.

seem to be same quality as oem but much less expensive. probably the same manufacturer. recommended

Fits my 2010 wrangler, name implies what it is. Quality is alright, 1 plastic like piece was inside thati trimmed out to prevent it from entering my cooling system.

Fit is perfect on early model JK. No gasket needed as the thermostat O-ring seals the housing and you should replace thermostat also if you are doing the housing. Go easy on the mounting bolts (~10-12 ft lbs) for a proper seal. Everything working perfect so far. I will update this review if there are any issues with reliability.

A perfect fit for my 2008 Jeep JKU Rubicon with the 3.8L engine. Combined with Motorad 656-195 thermostat (Amazon $21), both these items solved my leaking thermostat housing. In my photos, the new combo is on the right. The last picture shows it wet underneath the thermostat housing but that is from the removal of the old one. Some may say to use a gasket but i didn't and it's not needed. Also remember to "burp" the coolant system ! i tried the funnel kit but it did not seal with it's rad cap, so i had to run the engine , with the rad cap off, for 15-20 minutes to get the air out (this is the messy way of doing it). Highly recommend.

Muy buen plástico sigue al 100

Perfect replacement for Jeep Wrangler JK 2010.

No mess ,no fuss Simple duplicate of the original