Malida Male Push To Connect Tube Fitting,water purifiers Quick Connector Drinks Dispense and water filtration system fittings (3/8 NPT Male x 1/4 OD Tube)

Work very well, as advertised.

Go, the item seems to be built well with a solid push to connect area. The length of a threaded part is too short and results in the fitting bottoming out well before the threads make a seal with the O-rings.

Got these to put together some automatic chicken waterer. They worked perfectly and were easy to install & none have leked so far.

Ppm is a minimum change.

Bought these for outdoor project had to use pipe dope to sill. The threads are npt but don't have a tapered so the don't sill against thread. Had to sill at end of threads to keep from leaking as in pic. Don't use indoor whatever you do.

I buy this item with caution because some peoples did bad comments but after tested 1 bag I can say this is the best quality for this price. My second time I request 60pzs.. highly recommended !!

the product is seemingly well made and offered at a good price, but the male thread is not a north American standard tapered 1/2" pipe thread (NPT, National Pipe Tapered), and its OD is undersized. It might be a loose tolerance straight thread (NPS), but i suspect that it is actually G1/2, so 55 deg threads vs 60. It can be used if proper care is taken by installing the proper EPDM O-ring at the shoulder after smoothing both this part and its mating surface and a few raps of PTFE tape to tighten the m-f thread engagement to prevent excess wiggle.

Seal tight w/o need of clips.

Lo usé para un control de una máquina hoshizaki