Happy-motor Black Forward Control Foot pegs For Harley Softail Street Bob FXBB 114 FXBBS Low Rider FXLR 107 FXLRS 117 2018-2022

I actually owned and installed the chrome version from Harley on my old bike, this is a direct clone but in black. Of course it is much lighter because it is aluminum instead of steel, there are pros and cons for both types of materials obviously. I loved the Harley brand forward controls in chrome, so much so that I was going to powder coat them black for install on my new bike, I’m glad I found these first. These do one thing better than the Harley brand, the brake pedal has the rubber pad pre installed, that was very difficult to do with the chrome set from Harley. I did take one star off because the bolts stripped out on me, they are still good and tight and I’m sure I won’t have an issue but I wasn’t able to hit the torque specs because of this. I would use the original bolts whenever possible, I don’t think I’ll ever be able to get these off because they are stripped. However I absolutely love the forward controls, better braking power, more comfortable, and shifts nicely. I felt unsafe using the OEM mid controls because braking is so awful.

I'm always skeptical from the cheaper Chinese manufactured Harley parts that you find on amazon. For the most part, "they'll work" but you can tell that the quality control is not the same. In this case, I feel that the product is pretty darn good. To begin with, it was well packaged in foam to ensure that nothing was scratched. Second, it included good instructions to install the controls. Lastly, parts seem to be good quality without over paint, casting marks, or visible defects.Now, full disclosure. The shifter arm and a couple other parts are cast aluminum, as opposed to steel. Harley uses steel... Chinese manufacturers do not. I'm sure they'll hold up fine, but don't fool yourself that you're buying an equal product. Second, the threads on the shifter arm was painted over, so it took a tap to clean the treads so that the toe peg could be screwed in. If you're an average guy that works on your bikes, it probably wouldn't be a concern, but I'm writing a review, so I need to point it out.Overall, I would buy again. Time will tell if I should have bought OEM, but I'm happy so far. (Seriously impressed with packaging, though... you just don't see attention to detail like that on this site often).

I've tried other aftermarket forwards in the past, and this one was hands down the best. The packaging is superb. I only mention that because you can tell this company goes further than most of the other competitors. The brake arm and pedal give you way more leverage over the stock mids on a low rider st. It's almost worth it just for that. Only reason I didn't give 5 stars is due to the hardware. The hardware is low quality, and strips out way before torque specs. Use original hardware or buy new from a hardware store.

Amazing quality!

Fit and finish are fine, however the bolts are not the best, I used the original for most areas with no issue

Removed previously installed forward controls kit that was damaging boot/shoes and left side was 2.5 inches too short. That other one on here. Installed this one and looks like factory upgrade forward controls and are absolutely perfect positioning and farther forward than others and good quality finish.

These went on very easily. A lot higher quality than the other cheaper kits. Only thing I had to do was counter sink the shifter side hole where the pin goes through for the peg so that the e clip would go on. Not noticeable after installed. Good product, I am happy!

It works and looks great but the only issue I have is that the left peg sags and need to figure how I can fix that