Xenocam 1/2.7" CCTV 8mm 3.0 Megapixel Board Lens Black for Security Camera

I installed this to an industrial high speed camera and seems to be of decent quality.There is no IR filter but that was build in to my camera so it was not needed.

I tried this on 3 different cams with numerous spacers and could not get the lens to focus. I tried reaching out to the vendor but did not recieve a reply. Back it went.

It is this good lens that I was looking for

I got my cover back on, but it left a little gap around it. Everything still works, including the night mode and IR LEDs and sensors. Easy to focus.UPDATE June 2021:Pro Tip: You do not have to take the whole WyzeCam apart to install this lens! After doing a few of these, I found this super simple way to do it.1) On the front of the cam, you'll notice between the original lens and the black plastic surround, there's a rubber gasket there.2) Insert slotted screw driver between the lens and the black plastic surround. You'll need to push the rubber gasket in. Don't worry, just go slow and steady.3) Pry the black plastic piece off using the original lens as a lever. It'll pop right out.4) Use a pair of pliers to unscrew the original lens. It is glued in, so it will take some force. I've done this a few times and never lost a camera doing it. I did lose a camera by disassembling one, when the ribbon cables frayed, so in my experience, it's safer to keep the cam intact and force the lens to unscrew by breaking the glue with a bit of strength.5) Screw in the new Xenocam lens. If you screw it in until the set screw for the zoom touches the white case, it'll be almost perfect. Depending on the range of view, you might need to remove the first set screw and continue screwing it in.It sounds kind of scary, but it's pretty easy once you gain the confidence to use a little force. The improvement in image quality is amazing. I'm using half a dozen or so right now and loving every minute of it.

No tiene buena resolución, recomiendo observar otras opciones