A-Team Performance 110011 Universal Electric Radiator Fan - 2400 CFM High-Output Radiator Fan - Reversible Push/Pull Operation for Automotive Use - 14 in, 12V, Pack of 1

It seems to be blowing harder than the 1750 CFM that came with the setup I bought for my 87 ranger v6. It's keeping temperature at 187-190 with A/C with 90* ambient temperature. I will update if anything changes better or worse.

purchased to replace ac condenser fan that went out on my 98 Damon Ultrasport and was perfect fit down to the plug .... working great !!

Works perfectly mounts are kinda wimpy

Being honest, the first fan I received was defective, but received a replacement as expediently as would be expected. The second fan I got works great, exactly as described. The directions can be confusing for people new to auto repair, but YouTube would make this an easy install. I do strongly recommend using a shroud with this fan as it greatly increases cooling effectiveness.

Replaced the 10 inch cooling fan on my AGT LRT23 with this fan to cool it better. Drilled some holes in the old shroud and bolted this new fan up. Probably about a 15-25% increase in cooling. Will update if anything goes wrong.

So far it feels like a quality unit, came with easy to use hardware for mounting it to any radiator, install took me all of 15 minutes wiring included, will update with longevity in 6 months or probably forget to but if it stops working ill change my review so if this is still up its still goin strong

Using cooling push fan on my mahindra 4110 tractor radiator. It is working well. Only thing i did not like is switch included in pre wired switch/ relay set up has a red light that is constant when fan is off. This creates a drain on battery when it sets long without running. I used power from headlight switch on tractor to energise relay instead to eliminate possability of battery drain and for ease of use for me.

This product was used in a ventilation system. After approximately 60 hours of service, there was some bearing noise. Unusual operational conditions exist and are as follows: This unit was designed to run in an automotive environment (reasonably high temperature) This one is running at near room temperature. The unit is also running on a variable voltage supply (5-13.5V) and is modulated by thermal loading. I have two of these units installed and both are exhibiting the same condition. I have only reduced to four stars due to the cost effectiveness of the units. Otherwise they work great (move a lot of air).

good flow and easy to mount but I made my own bravkkets

Durable muy bueno lo puse como auxiliar en una jeep gran cherokee y sigue jalando

car does not run at 200 any more

The fix was not perfect but so far I can get by until I get the original replacement..

They say the noise level is 49 db. It is MUCH noisier.