iMusk 1 Pair Replacement Mini 3 Pro/Mini 3 Vibration Absorption Gimbal Camera Damper Rubber Cushion Repairing Parts for DJI Mini 3 Pro Drones

I had what most would consider a very minor crash of my Mini 3 Pro -- 3 feet off the ground and over grass. But the twig that OA didn't see knocked my gimbal/camera hard enough to dislodge the damper on one side. After watching a YouTube video for how to install this part, I decided to attempt the repair on my own rather than pay DJI to do it. It wasn't easy, but I did it and I'm now flying again. I only needed to replace the side that did not have the cable running through it, so no tools were required. I did use painters tape to hold the gimbal still while working on it. Getting the tiny holes in the damper stretched over pegs that secure it to the gimbal was the hardest part. I really had to pull and stretch to get each hole properly seated over the pegs. If I have to do it again someday, it will go much faster. It was my fear of tearing the new damper that kept me from stretching hard enough to get the job done. It is important to note that one peg on the gimbal mount is slightly wider than the others as is one of the anchor points on the damper. These must align. One mounting slit on the drone body is also wider than the others and this must align with the wider anchor point on the damper. The repair worked. The gimbal shake at startup went away and the drone calibrated successfully. So, I'm happy. I would definitely recommend watching a Mini 3 Pro gimbal repair video on YouTube before attempting this installation. I couldn't have done this repair without seeing how it is properly done first.

These are excellent products and make replacing the gimbal support rubbers / bushing a breeze! Just do not be afraid to stretch these little buggers over the posts on the gimbal completely. They are quite forgiving and stretch a lot without fear of tearing... well made. Fit perfectly. So well, I ordered two more just in case for my other 2 mini 3 drones. Other than the 9 days it took USPS to get these to me from only 108 miles away (a 2 hour drive) I am very satisfied.

Had a lil whoopsie w/ the ol bird 🦅 Ripped all 3 rubber straps on the ‘non wire harness’ or ‘driver’s side’ gimbal boot. These boots were not labeled for the mini4pro but for $12 it was worth a shot and worked great. Pretty simple fix and doesn’t require anything but a pair of pliers. Having someone hold everything while u change boot is recommended too if u got it. Be sure to re-calibrate everything prior to flying 👊🏽🦅😎

Replaced this part on my mini 3 and it partially resolve my shaking video problem.

So the OEM one on mine popped out, but wasn't torn. It was the the right one (when looking directly at the drone) so it didn't have the wire running through it. I was able to remove only the one arm cover, and and gain access to that side of the gimbal. After figuring out how it was held on (there's a video on ifixit ). I tried to reinstall the OEM one, and got it partially fixed, but there was no way I could fit the rubber back into the holes. It was just impossible, every device I used just cut right through the rubber when trying to push it. Had I known that'd have been so difficult I may have tried harder to not have to remove it... not sure if I'd have been successful on that. Anyways, ordered this device, and the whole process took maybe 5 minutes. I just started the drone and it seemed happy. Recentered the gimbal and everything appears fine. Rating it 4 stars because the price is obsoletely insane. This is just a little rubber item.

Fit, build quality, and functionality are all excellent. Easy to install and at a good price!

These worked perfectly for repairing the gimbal movement. Just buy two pairs as it's somewhat easy to jack up the rubber tips.

I managed to get it fixed. Just be careful while installing them.