iCrimp Ratchet Wire Crimping Tool Set w/ 5 Interchangeable Jaws for Insulated and Non-Insulated Terminals AWG20-2, Wire Stripper included

Buena calidad y muy funcional!

na jaar gebruik, nog steeds een goede tang. knijpt makkelijk

My only regret is that I didn't buy this set sooner.At my workplace I had to constantly borrow tools in order to crimp Delphi weatherpack/metripack style terminals, and the crimp tools that I used were extremely basic non-ratcheting types. This made it fairly time consuming to crimp terminals because I had to essentially hold the wire and the terminal together while positioning the tool and crimping it. I finally caved and bought this set.To say that it made my life easier is an understatement. The ratchet action and big handles makes it trivial to get a proper crimp- simply place the terminal and ratchet until it holds the terminal in place, slip the wire through and then squeeze the handles. You get a proper crimp that is positioned where you want it when the jaws release, and it places no additional stress on your hands.The wire strippers are very decent. Chunky handles, a light spring and sharp edge makes it fairly easy to strip insulation, and the lock is pretty handy for storage.Keep in mind that the A03BC jaw set works for the terminal to wire connection on Delphi metripack/weatherpack connectors, however there is no specific jaw for 'crimping' the rubber seal at the end of the terminal (which requires a perfectly round crimp jaw). The picture shows just the wire interface crimped with the seal uncrimped. I found the A10 10AWG hole to work well enough however. I have not tested any of the other crimp jaws but will update this review if required.Overall, I highly recommend this tool. It feels like a quality piece for something so inexpensive, and it actually made the experience of wiring actually fun and relaxing.EDIT 8/10/2017: I used this crimper with the cheap red/blue/yellow terminals. Usually these things are junk because they never crimp properly- and I think most people simply solder them. However, I crimped them with this today using the A30J jaws and the results were fantastic. While this doesn't make the square imprint that specialty crimpers would have, the crimp was strong enough that I couldn't pull the wire back out; the plastic insulation was also shaped so that the end 'cupped' the wire properly. If anything, this was even more impressive than the Metripack crimps I did earlier.

I'm a DIY person, not a proffesional. I never knew the strippers/crimpers that come with almost every wire connector set are not even made for them. Have you ever noticed about 1 out of 5 connectors actually hold tight onto the wire, and fall off with minimum movement. Not anymore. These come with like 5 or 6 different jaws for every type of wire connector out there up to like 12 or 14 gauge wire. These crimpers work so good I had to review them and I show them off to everyone who comes by. I am a real person, not a bot.

Me encantó, se ve increíble y el estuche muy bonito:D