Malco FST2 Fin Straightening Tool

Nice product

I could not believe how easy to use this tool is. The results were incredible. The previous owner used a pressure washer to clean the coils, and flattened quite a few areas on the coil. The A/C repairman recommended getting a new coil, I never got a price, but I managed to straighten almost all of the fins for $50. Can’t beat that, this thing works and works well for anyone.

السعر 130 ريال وكنت اتوقع الكاولتي عالي لكن للاسف مصنوع من البلاستيك لو الاسنان مصنوعه من الالمنيوم او الحديد اعطيه 5 نجمات

يمكن تم تفصيل شعيرات المنتج على مكثفلت غير موجوده على سطح الارض جربت على السيارات الجابانيه والامريكيه ولا يوجد تطابق بين الشعيرات وشعيرات المكثف

I initially tried a metal fin straightening tool from Lowe’s (also sold under different brands on Amazon), but it was a total disappointment. Within five minutes of use, it fell apart. The small wire pieces meant to straighten the fins kept getting misaligned, and it was clear that the metal pieces weren’t properly crimped. I returned it as defective and decided to do more research before trying another tool. I came across this new tool and watched a few YouTube tutorials, which was crucial. A tip I found helpful was to avoid forcing the fins. Instead, gently slide the tool up and down in both directions, taking your time. Be patient on damaged/bent fins and work from the edges toward the center, focusing on one section at a time rather than diving straight into the middle of the bent fins. If you encounter resistance, don’t push too hard as you might tear the fins. If the tool doesn’t go through in one direction, try approaching the fin from the opposite side. Sometimes a damaged fin can block your progress, but by alternating directions, you can straighten everything up to that damaged point. This tool worked much better for me, and with a little patience and technique, it got the job done without causing further damage to the unit. I attached a photo with before and after pictures. The before pictures are on top and the after pictures are on the bottom.

This product is poorly made and does not work at all for fins that have been bent too far.