MT190-SK Smoke Led Tail Light Brake Light with Integrated Turn Signals Indicators Compatible with 99-00 CBR 600 F4/ 04-06 CBR600 F4I

Exactly like picture

Product looks amazing on my bike. Fits well but does move a around more that I would like it too. Installation is not too bad but does require some wire splicing for it to work on my bike. The attachment that it came with did not plug and play as described. Also, quality is average. Had to get if replaces the first time I got it due to motherboard not working.

The light works well after having to figure out the wiring without instructions. I attached photos of the correct wiring for my 2006 Honda CBR f4i. With these, the installation should be a breeze. I would recommend getting clamps to attach the blinker wires. O'Reilly's or any auto parts store should have them.

Worked great for a couple months, but one of the wires fell off the circuit board inside the tail light a couple days ago. I'll have to solder it back on, but otherwise the turn signals and brake light and everything worked fine.

It fit perfectly and looks great!

This was a perfect replacement for my oem one. Fit perfectly, very bright. I didnt even have to use the resistors on my ancient bike. (99 CBR600F4)

So I see a lot of people on here complaining about the wiring and not having any instructions. Well, it’s literally only 5 wires. Two are obviously for the turn signals (loose wires) and the other three that are part of the connector are for the brake light/running lights. I DID HOWEVER THINK I WAS GOING TO HAVE TO HARD WIRE DUE TO THE WIRES BEING “MISMATCHED” or “WRONG” on the yellow connector compared to the way the existing plug is configured. Here’s the FIX: In the picture I included with this review you can see that the other (black) connector from my previous aftermarket tail light has 4 wires to make connections in the plug, and the new connector (yellow) only has 3... I though maybe this was the problem but after playing around with an electrical tester it finally dawned on me, all I had to do was fold the two wires over to the opposite side of the connector to correct the issue! Thank god because I suck at soldering. I also ran the turn signal wires out through the small holes around the outside of the big hole where the harness plugs in to the tail light housing (the assembly came with these wires running out of the big hole and doesn’t allow the plug to fit or seal) not a huge secret there but I figure it might help some of ya. I will be updating my review if this tail light ends up be worth less than the 29 dollars or whatever I paid for it. Cheers! This worked for my 2004 CBR600f4i

Great looking light, easy to install.

Muy buen producto y muy buen precio!