KENDO 10 Inch Circular Saw Blade Set, 2-Pack 40T 60T, 5/8 Arbor | Two 10 inch ATB blades for table and miter saws: 40T for ripping, 60T for plywood, MDF and laminate finish cuts

OK, I will admit it: I bought these blades because they are inexpensive and I had made some drawers that had 23 gauge pins in them that I had to cut down. Rather than take the chance ruining a good blade, I figured worst case I will ruin a $10 blade. I put the 60 tooth version in my table saw and I was absolutely amazed by the quality of the cut I got, both on melamine faced particle board, and the drawer stock. As I fed the drawers through the blade I did see a couple of sparks (probably a result of cutting through the #23 pins) but the overall quality of the cut was superb. After cutting the drawers I continued to use the blade to cut that 3/4" melamine faced particle board and the results were equally wonderful; virtually zero chip out that I can see on the melamine. I cannot vouch for long term usage since I have only used the blade for a few days but I am incredibly impressed by the quality of the cut I got for such a low cost...I'm a happy camper and have no reservation about recommending the 60 tooth blade. I have not tried the other yet. Attached is a photo of the melamine faced particle board just cut with this blade.

great product, worth the money.

I like the blades they are sharp and smooth cutting. I ordered what I thought was 4, 40 tooth blades but I got 2 40 tooth and 2 60 tooth, other than that I am pleased with my order.

Nice for the price

It worked fine good price

Cuts good, fast and clean!

I bought these for a new cordless saw. They fit great and cut very well. Make sure your saw has around arbor cause these blades don't have knockouts in em for diamond arbors.

Very impressed with this blade. It is sharp and clean cuts. I put it on my miter saw and it cuts like butter. So then I purchased another one for my table saw. Well worth it and the price is right.