12V 30A 360W Universal Regulated Switching Power Supply LED Driver | ±15% voltage adjustment, 3 output channel, temperature-controlled fan, ideal for strip 3d printer cctv and amateur radio

Too big to fit in. Needs a lots of space.

جيد وأتمنى أن يدوم أثناء استخدامه .. والجميع يعلم أن الأدوات والتجهيزات الكهربائية لها مواصفات لا يعلمها الا من صنعها ومدى مقاومتها وكفالتها

المنتج كويس جدا وصل جديد زيرو وزي ما مكتوب 30 امبير فعلا لو هتحتاجه لمشاريع هنديسه هايفيدك جدا

I used this to power two 6" fire alarms I use for Doorbells in my dyno/machine shop. Screws to mount it are 4mm X.7 I cut them down to 1/2" long and mounted on wall. Easy to wire. Not super heavy duty on connections, but sufficient. Works great.

Works great for my diesel heater 12v

Works as described

Update 9/21/23 So far no negative issues to report. Bought a second unit and am now running them parallel providing a 60 amp base supply at 13.8 volts...both units set at exactly same voltage with a 4 decimal volt meter for exact match to run a larger linear amplifier pulling as much as 50+ amps for extended periods (long QSO's or talk sessions). I have not experienced any issues with heat buildup, power fluctuations, voltage drop is negligable and mine have not shown any problems with grounding (my entire station is well grounded) and I do check my individual components - Not dismissing others comments, just saying I have not experienced a grounding issue. Have recommended same unit to my Son who is also a radio operator. Original post: I am using this at14.26 volts to power a small Ham Radio Amplifier providing solid voltage (love the very adjustable output voltage) and solid amps during peak transmissions. The unit provides adequate power to provide a solid 200-225 watts out to antenna from the supply. The thermal fan control works (no constant fan running like some other of these smaller supplies), voltage drop is less than .3 volts at the 225 watt output peaks....we shall see how it goes for long term use but so far I'm pleased with performance per dollar....will buy again for a parrallel twin supply setup if I see no issues over the next month (will report back). For those HAM's worried about whether for HAM or CB, I'm a licensed Ham Op. so you can save those negativities for someone else.