MADE IN THE USA - Heavy Duty Hardened Primary Clutch Puller Tool for Kawasaki UTV/ATV Mule/Brute Force/Prairie Replaces PCP-10 57001-1404/57001-1429

Solid tool works well

Worked well. Was able to pull the clutch on a Kawasaki Brute Force. I used a impact gun, on the bolt, but it didn't take much effort. Came right off. I did not have the "pop" as others have stated. Also no problem with the puller after use. Still looks new. Did not crack, peen over or break.

Best customer service I have gotten in years. KNS answered all my questions and even gave me some technical advice. The job went great. The tool was great

It came with no instructions. Found out the hard way it will screw up you crankshaft threads. Do not tighten it tight just by hand snug like a spark plug than tap with hammer I think that might save your crankshaft. If end was a little bit bigger were it didn't go into the edge and stayed outside it would have been better had to drill out frist 3 threads than run a tap remember crankshaft is harder than harbor freight taps but it was off with 1 tap. But information would had been nice

Used this on 2003 Kawasaki Prairie 360. A little anti-seize on the threads and it worked perfect without any signs of wear. Looks like a quality product.

Great quality!!

Worked like a dream just screwed it in and it pop the watches right off

Quite happy that I purchased a hardened tool as the pulleys were difficult to remove and required over 65# of torque WITH THE TOOL to remove. Any non-hardened tool would probably have broken/sheared which would have created a nightmare to remove & repair.