VEVORElectric Hoist with Remote Control, 440 lbs Material Handling Tool, 110V Electric Hoist with 14ft Remote Control for Factories, Warehouses, Construction Site, Attic

Very powerful. I used this in construction of my attic lift. The best part about this lift is the dual controllers. One is portable and the other is hard wired. Perfect for my application.

works great. if needing a rail to slide the hoist on, be sure to get the correct clamps to install the rail correctly and easily. This hoist works fantastic and is quick and quiet.

This was exactly what I needed for my garage. Lifts my generator to the back of my truck. Lifts my outboard motor to install in the spring and take it back off in the late fall. No grunting and back strain no more. Also lifts front of my zero turn mower for deck cleaning and blade removal and install.Should have purchased earlier.

Nice product, Seems well built no issues as of now, easy to install, Fast delivery and Packaged well

Installed great, but out of the box it wouldn't run. Turns out that the controller has a button that was shipped in "locked" position. You had to turn it out of locked to work.Would have been helpful if the user docs had mentioned this.

Well made. Very strong. Exactly as described

I bought one of these winches a few years ago. Works well so far, I use it to store my 5th wheel hitch up in the overhead of my shop. It only gets used when removing or reinstalling my 5th wheel. It is a little noisy but that is to be expected on a winch in this price range. So I bought a second winch to put on a rail in my shop. Surprisingly enough it is somewhat quieter than the first one and seems to function OK for what little I have used it. My problem is with the poor final assembly of the winch.Photo 1 - One of the welded on nuts used to install the hanger brackets on the winch was welded in at an angle.Photo 2 - The spring, washers and safety stop disc (Red Arrows) were assembled on the wrong side of the swedge. In this configuration the traveling block cannot be used. I removed the swedge, positioned the parts on the cable where they should have been and place a clamp where the swedge was and put on the traveling block.Photo 3 - The washer was the wrong size to keep it from being dragged into the traveling block. Fortunately I noticed the problem before it was under load or it would have damaged the spring and other parts. (Red Arrows)Photo 4 - I cut the end off the cable, removed the lower washer and replaced it with a fender washer (3/16" X 1 1/4") so the hoist stop would not bind with the traveling block and allow it to operate as intended. Then I put 1/8" cable clamps were the swedges had been.Evidently they don't do much for final inspection on these winches before shipping them. These were problems that should not have happened and if they did, they should have caught them prior to shipment. If I had used it like it was delivered the safety stop would not have worked as intended and likely damaged the winch or winch parts.

Great for the money