Vertically Driven Products VDP 31550 Stubby Bumper End Cap

Very easy to install. Took me less than 30 minutes. You'll need a sawzall with a carbide tipped metal cutting blade, and a drill with a 1/4 inch bit. Mark off your bumper as directed, doesn't matter if it's exactly 3 1/2 because the cap covers it. I used one of my cheap worn out old wood blades to cut the plastic off first. Then cut the metal bumper with the carbide tipped blade. I didn't want to pony up the money for a Diablo or Lenox blade so I got the 3 pack of EZARC carbide blades from Amazon for around 20 bucks. Worked just fine. Used 1 blade for each side and still have an extra left over. Probably could have done it with 1. After cutting, put the caps on and predrill the holes in the remaining plastic of your bumper, pop in the pins and done.

These end caps were so easy to install and make the Jeep look great. Much more economical and looks better than replacing the entire bumper. Easy to install once old bumper ends were cut off. Fortunately I had a friend with a saw.

If you can use a measuring tape, reciprocating saw and drill then it’s a pc of cake to install. Instructions very clear and it’s about 2 hr job ( I took my time ). I used my grinder to straighten my cuts and took off sharp metal corners. I also painted the raw metal ends to help prevent rusting. A great look without spending a few hundred for a new bumper. Very pleased and satisfied with end results. I would recommend this product and would buy again.

I purchased my 2012 Wrangler used. It had a love tap mark on the end of the bumper that bugged me to no end. I had been looking at these caps for years but the act of cutting off the ends of my bumper was frankly frightening. I finally pulled the trigger on these and it turned out to be the easiest modification I've done on my jeep. All you need is a sharp sawzall blade and some courage. "Just do it"! Great instructions and YouTube videos help as well. Turned out great. The caps are sturdy as a rock. Very thick material. Still can't believe they are only held on by those plastic panel pins. Make my bumper look 1000 times better. A must get item.

Been looking for a bumper that wasn’t a lot of money. This is very affordable and super easy to install. It was done it 20 min and it is a great look on the Jeep.

Fairly easy to install. Look good. And they are sturdy. Just a little on the high side, price wise.

Overall this is an easy peasy install if you're comfortable using a reciprocating saw or heavy duty cutoff wheel to cut the ends of your factory bumper. A Dremel tool isn't going to get the job done. The measurement to cut off in the instructions doesn't have to be dead on accurate. Close to it and reasonably straight is fine. The caps themselves are a perfect fit and look about as close to factory fit as can be expected with an aftermarket, mass produced part. If you like the stubby front bumper look and don't want to spend the $$$ on a steel bumper or just need a little extra clearance for 35"+ tires, this is the perfect solution.

Easy to install. Like some others I cut the plastic part first, the cut the metal about 21/2” for more support. Cut is not critical as the end cap fits over the cut. I got some black caulk for the seams. End caps match the style of the original end caps so they look like they belong. Gave me the clearance I needed and looks good.Hardest part is taking the saw to your bumper.