Eightwood Aluminum Electronic Project Box Enclosure, 4.72 x 3.82 x 1.57 in

I bought 2 of these to house a couple of preamp boards , I finally got around to working on them, the board fit nicely in the integral slots furnished in the sides , they where 3/8in. To long so I cut them on my chopsaw down to size . They fit together nicely the screws self tapped into the cut end . Then I drilled holes for the knobs and rca jacks and used a hole saw to cut holes for the tubes , I think it looks great , quality product, I'm very happy with the way it turned out, Tim T

While my project is still in progress (as you can see from the unfinished polycarbonate front panel I made for the case), this is a great project case at a very reasonable price. The two halves of the case fit together perfectly, and while I didn't see it mentioned in the description, there is even a slot that could be used to slide a ~92mm circuit board into the case. The only thing that I can think of that would make this better is if it came with feet! I initially had some issues with the product as it was shipped to me, but the seller did a great job working with me to resolve the issue. Their quick response and clear communication made them easy to work with.

Great project case. The interlocking shell design is very functional, with one shallow and the other deep. I use the shallow side to mount the innards, while the deep shell enables them to be fully exposed for convenient access, only needing 2 screws removed.

Perfectly described, very good packaging, arrived in perfect condition. Based on machining I'd guess this is 6061 alloy.

I used this case to hold my signal tracer. Sure it is a LOT of strength for a small device, but you don't know my workshop, where things seem to fall on the floor from great heights. You see my daughter has 3 large (BOBCAT size!) 🙀 that walk on my shelves and push things off when they are, well disturbed, and they are disturbing cats! This matches the all channel radio that sits on the same shelf, it was built in China and took 3 damn MONTHS to get here! Talk about the slow boat from CHINA! I was about ready to cancel the order! Perhaps I just should have, as the radio was disappointing. I built one from a kit that cost half the price and performs twice as well should have bought that one FIRST!

Good quality clean extrusion. Nice anodized finish.

This little box worked perfectly for my needs. Quality build!

Nothing to dislike. As good as I could have wanted.

I needed a small case for a radio project I was working on. This case met the need perfectly. It fits together well. If there are any downsides, it is that the black iodized paint does scratch easy.

I used this to house an STC-1000 temperature controller for an aquarium heater. It was easy to work with and exactly the right size. Everything fit as expected from the drawings.

Heavy duty aluminium box, matt black finish, easily machined etc.

As described, works as intended