IwataAir Gunsa 1.8 Hvlp Primer Gun (9236)

I use this gun for spraying direct to metal primer and water base primer it works very well I’ve been very pleased with it. It doesn’t feel cheep and the gun will last a long time if proper cleaning is done

Easily worth its price. Well made. Repeatable results because adjustment settings are consistent and repeatable each time you spray with it. Here’s the deal: the cheap gun requires you to buy two or there of them so to not get stranded in a paint job or to have parts. $60+ right there. Modern paints require controllable fine atomization and a cheap gun will not atomize well enough nor develop the fan size required to carry a wet edge across a large car or truck. This gun sprays Nason Ful-Poxy wet, wide and fast enough to use the product as non-sanding sealer...a huge work saver. This gun in a 1.8 and a 1.3 would be all the kit you need. Otherwise with the cheap gun you pay for an expensive gun in wasted time and materials without the benefit of owning a quality gun. Spraying a trailer with cheap tractor paint? Go with the purple. Paying 500$ for premum paint? Go with a gun on this level. W400 and GTI Pro-Lite in the same category. In the end considering the savings in costly malfunction and re-sprays prevented, this gun is cheap. No disappointments here.

Used daily to spray 2k primer. Lays product down fairly well with minimal orange peel. One minor complaint is that the air cap feels cheap if it's dropped while cleaning I'm sure it would bend easily

I just used this gun tonight to spray some 2k high build. I am very impressed how well it performed. I sprayed some small spot repairs and it did really well with the fluid nozzle turned down. I also sprayed a larger area where I opened it up. It can put out a lot of product fast and smooth. Very impressive for the money!

Great quality, and great gun. Easy to clean, lays down primer well.

I purchased this to replace my 3m Accuspray gun to shoot primers. I could never get great atomization out of my Accuspray. So far I've shot some Evercoat Superbuild polyester primer and Kirker epoxy primer. They both atomize like they are water and with little practice and adjustment they dry with almost no surface texture. I found I could turn down the inlet pressure a bit from the 2 bar spec and still get excellent results with a little less over spray. Can't wait to try my LPH 400 for base and clear.

Not even 1 month .My son used it and then it was leaked.

I bought this to replace my old sata primer gun. The gun is not bad but it’s definitely not as good as my Sata was. The fan isnt very big and it’s not an HVLP so you’ll need to spray at a higher pressure to get good atomization. For the money..this gun is not bad. It lays the primer on pretty smooth once you get it dialed in. I don’t regret purchasing it.