Wilson 305-830 18-Foot Belden Coax Cable with PL-259/FME Connectors - 18FT

Works great. I was having a coax issue in my set up.. purchased this and problem solved and SWRs now under 1.5. The removable tip so you can swing it over to the passenger side from driver side is a huge bonus to have

Works great

The cable is well designed and built of good materials. The removable PL-259 made the installation a breeze. The only issue I had was a poor solder connection on the PL-259 center conductor. There was solder on the outside of the weather boot end Pl-259 center pin. It wouold have been a poor fit and not what I expected from a higher quality cable. It was easy to carefully remove the excess solder with a very fine file. I was unable to find a way to notify the supplier that they need to check stock and address it with Wilson. Hopefully they will see this post. Delivery was excellent by the way. Best Service Stores delivered fast. In their defense there is no way they would have noticed the solder issue. I consider them a top notch vendor for price and delivery. I just wish I could notify them without going thru Amazons filters and categories. None of the selections were "helpful feedback" from a happy customer. All the other choices would not have been fair so all I have is this post.......... UPDATED 11/14/15 - Important install note: The cable survived the sun, mud rain and snow for over 2 years but then failed due to my install method. Use caution if your antenna is on the door and you need a cable that will flex with the hinge action. I ran my coax thru the factory gate wire chase which holds it to a very limited space. It eventually broke in half with the constant opening and closing of the gate. This is a very well made cable but bear in mind the specs and construction of a high freq coax is not the same as every other 12V auto wire. I am happy with the cable quality and replaced it with another wilson 305-830 but this time I added a large loop to limit the flexing. If i have any other trouble I will post here.

Nice braided coax cable with a removable end which makes routing through the vehicle and connecting to the radio much easier. Price is fair for what seems like an above average quality cable (connectors are not marred, sheathing is nice). Length worked well for running from the truck bed to the cab along the frame rail. Thin enough to route through most vehicle grommets. Worked well and was compatible with my Cobra radio.

So far so good A little long for where I ended up locating my antenna, but I'd rather have a little too much than not enough. And the factor that it has an end that threads off, so you don't have to drill such a big hole is nice.

As ordered

Being able to remove the fitting on one end of the coax made it super easy to feed through the firewall grommet on my truck. So much easier than having to cut and crimp or cut the grommet causing a poor seal. Highly recommend this coax if you have to go through a grommet!

This length cable gives you enough to be able to hide the coax out of site when installing CB

Installed this on my 4 door Jeep JL Sahara with a President McKinley CB radio. Having the smaller end on one side makes it a lot easier to fish the cable through the roll bar trim and to an overhead CB bar I bought from the states. Works great and the connectors are strong.

Buen cable funciona muy bien

Facile à utiliser! Parfait pour un Jeep!

Buen cable fácil de instalar y buena calidad del producto, lo recomiendo

This was perfect for my jeep set up.