NVMNT1016 - Remote Control/Handsets for Roller Shutters 433Mhz

Excellent quality, original badged NVM item.Works with NVM NT1004 garage door controller.To program the fob:Remove the controller cover by pressing in the tabs at each side and lifting the cover up.Press the round black switch once (it's located above the 3 toggle switches) the LED on the controller will flash, press the ⬆️ button on the fob and release.Test the fob and replace the controller cover.If it doesn't work press and hold both circle and square buttons to clear fob memory and repeat above.Easy peasy lemon squeezy.

The buttons on our garage remote wear out around every 12 months which has been annoying as it’s cost £30 to replace - but thankfully no longer! Looked up garage remotes on Amazon and voila a replacement for half the cost! It arrived literally the next day and took seconds to set up and it works perfectly! Highly recommended

Good quality product, and very easy to set up using the instructions provided

I have found the seller to be very reputable, but unfortunately this just wouldn't pair with my Eurodrive control unit. I returned the item. fobMy advice would be to spend a little bit extra with the seller and purchase an original Eurodrive hob - I now have one and it paired with just three button presses!

The instructions were a little vague on how to program but fortunately the lads across the road knew what they were doing and had it programmed in under a minute.Great job and certainly cheaper than having to call out emergency after hours as you've lot your only fob.

Needed a new remote after one of mine stopped working.Looks same as original , paired super easy. Open controller box, press sw6 on controller board then the circle button on remote , job done , replacement for less than a third of the xost from garage door supplier

Activated in 2 minutes . Works well

Excellent quality and easy to connect.