Hogue HandAll Beavertail Rubber Grip Sleeve for SIG Sauer P320 Full Size

Used on a Taurus TX22. Fit great. Once on after heating it up, the palm swell made the grip fit so much better. I had grip tape for improvement before, but it was still too narrow. Great now!

The as said this would fit a Sig P320. When it arrived, the package said a P320 FULL SIZE (see 5th pic). That was concerning, since mine is a compact, but there was no need for concern. The directions say to cut two 1” wide shoe horn shapes out of width of the plastic package, but make them from the length so they’ll be long enough (1st pic). Combine that with some Windex-type window cleaner, and the install is fairly simple. First I tried just some window cleaner and only got it about 1/2 way on, then had to struggle to get it off to start over. You know how much a shoe horn helps with a stubborn shoe; this is 2 shoe horns. Make sure you have the horns set so they will stick out at the bottom. The grip then slid into the sleeve without much effort. Then do a fairly light pull with a pliers, and horns came right out. The fit? Great! The grip of the P320 compact is about 1/3 inch shorter that the full size, but, there was NO overhang at the bottom (2nd pic). I did have to trim a little from around both sides of the magazine release (3rd & 4th pix), very necessary for obvious reasons. That coincides with the compact having a slightly shorter grip. I used a small scissors so as not to scratch the grip. Now there are 3 ‘handy’ finger grooves that did not come from the factory. Nice product, I recommend it. The directions do warn that the install can be a pain, but the window cleaner + the 2 shoe horns made it quite doable.

Súper nice

It fits like a glove

I added the grip on the handle eight months ago. Not my grip of choice but options are limited. I like the fair amount of extra girth, it gives me more control. These rubber grips will probably last a long while. The one I put on my Sig still looks new. No wear marks or fading. Low cost and an improvement over a plastic grip, could be worth looking at.

It's a little difficult to install but if you follow direction it makes it a little easier. My plastic pice I cut out slid to towards the tip and had to roll the top of grip back to pull them out with pliers . Once on its a good fit and feels decent on the hand. Does make it feel thicker if you have small hand it could cause your finger not to hit the trigger right

Very happy. Quick delivery, works great. Thank you!

This grip for the sig 320 fill size will fit the FN 502 Tactical with very minor trimming at the bottom end. Since the FN 509 tactical is the same size as the 502, I can only assume it will fit it aswell. Pretty happy!

m17 co2ガスガン用に購入。個人的にタンカラーの色合いが安っぽく見えてアクセントになるかと思い購入しました。グリップ力も上がり、見た目も気に入り大満足です。

Perfect for people with larger hands and looks great when installed, very durable. Installing is abit difficult but soak the grip in boiling water first and it slips on easy and once it cools down its on nice and tight

元より太くなった分フィッティングが良くなった。 取り付けは大分きつく大変、そして大分太くなる為手の小さい人は完全に不向き。 実物のカスタムパーツなのか当方は詳しくないので分かりませんが、確りとした作りでした。