2.5" to 3.5" Internal SSD/HDD Mounting Kit, Metal Bracket Adapter with SATA 3.0 Cable

No issues in installing it to my desk top.

Cheap adapter that fit just fine in my drive bay. Screw holes line up perfectly with my Kingston SSD. The SATA cable has two straight connectors, not 90 degrees angle on one end. Not a problem for me. Doesn't have any RGB light stuff and I love it! You kids and your RGB madness :)

It worked just fine.Fitting to my computer and held the s s d drive in place

Had to purchase another model.

They were so many to choose from, so I went with "AMAZON CHOICE" Bracket Kit. IT turned out real Good as the KIT is First Rate. I know that other reviews have said that it is flimsy. It may not be up to Battleship Standards but, it will hold either a 2.5"/3.5" Drive just fine. Look the 2.5" Nano Drives are feather light and this Bracket is solid and it will hold them with no problems.The Chrome Plated Screws are also first rate and the SATA III 6GB. cable that comes within the Bay is Good enough for my money. ALL in ALL, this is a GREAT KIT.

Arrived on time and in good condition. SSD fit nicely into adapter, then into desktop. No problems.

I bought this to mount a 2.5 SSD in a Dell Optiplex 7010. It fit in the carriage for the 3.5 opening, but I had to ream out the screw holes, so the hard drive pins would snap in. The cable was perfect, since the original SATA cable was too short.

The main thing I wanted to note in this review is that the screws are all "CD ROM" sized. Most trays I've used like in the past have the smaller screws to hold the drive onto the cage and then normal hard drive screws to hold the cage into the computer. This one expects small screws to be used in all places, including mounting the cage into the PC. Normally this isn't a problem, but if you have very specific screws that need to be used (looking at you Compaq), the holes are too small. Fortunately, the metal is so thin you can jam it in there if you try hard enough, I was able to use larger screws with some elbow grease.The other thing I didn't like is that this tray felt short? When I took out the 3.5 drive that was in there and put this in it's place, the connections were not set much further back into a place the cables couldn't reach. I'm sure it was only an inch or so, but it made me have to re-route the cables. Would have been nice if this set the new drive connections to be where they would be relative to a 3.5" drive, not recessed back so far.All in all, it works, it does the job and it's cheap. But if you have anything that a fairly generic layout, like a Compaq or Dell or something, you may want to skip this one and go with the Sabrent instead. I've had much better luck with that one.