APT Polyester Tape with Silicone Adhesive, High Temperature, 3.5 mil Thickness, Powder Coating, E-Coating (1, 0.75" x 72 Yds)

This product is hands-down the best tape I have ever used to assist me in filling open bezels with UV resin. This stuff will stick to any bezel I've tried. Not once have I had any leakage due to the tape. Leaves zero residue on the cured resin. This may be a drawback for you if you have dexterity concerns. It's very easy to attach to the bezel, but much more force is required to remove it from the tape. All positives in regard to my specific needs. I can assure you that as long as this specific tape is produced, I will be a customer. This product is just that good. This is your confirmation from the universe that this is the tape for you. Your search for the perfect tape will end here if you heed my recommendation.

I used this to tape a drip pan in my freezer – a silicone pan, in fact, designed as a pet tray. The tape adhered instantly and well to the cold, damp plastic of the freezer. The silicone not so much, but it's not under any tension and seems to be working fine. For my purpose, the tape serves to guide any water *into* the pan and not under it. I've tried my best to trouble-shoot the drips and replaced the coil sensor and the fan, but I still get drips so this is my solution – the silicone tray allows me to pop the ice off instead of banging on the bottom of the fridge to fracture it (I don't want to damage the fridge). Now I have 71 more yards to find a use for... I'm sure I will somehow. Good stuff!

I needed to purchase a heat resistant tape that was wider than the tape I see being used online by most crafters. This tape was almost perfect. It is hard to stick to the stainless steel inside the tumblers but this is the case for all of the heat resistant tapes I've used so I wasn't surprised. I have a method to make it work. I am definitely going to purchase again when I need to re-order.

Was struggling to get my prints to stick to the tray. Starting using this stuff, works perfectly! Still use glue but i think this melts slightly and creates a bed for the print to sit into. Highly recommend!

Didn't work for my application, I think I purchased this without doing enough research. It does not stick strongly to any surface, even after a few days. it is heat resistant. Seems to be designed to be a heat resistant masking tape, for which it may work well for the right buyer.

Great product for the money.

In case anyone was wondering, the inner diameter for the core (on the 1" wide roll) is 3". Seems to work well for holding things down for sublimation printing!

Great for masking areas when powder coating. Typically holds up to at least 2 oven cycles at 400 degrees.