FPV Drone Racing Tiny Whoop with 720P HD Camera Micro Quadcopter, 8.5mm Motor Powerful, High -Voltage Battery, Automatically Increase Stability BNF Version (FRSKY)

Flies good weird binding procedure but easy could be a little faster in horizon mode.

I was pleased with the speed of delivery and the condition the drone arrived in. I am a little upset with the flight. I bound the drone to my transmitter and went outside for my maiden flight. Upon arming the drone it went into full throttle, would not respond to commands from the transmitter, and promptly flew away. I am trying to find the drone, but I have little hope.

This thing blows propellers off, and I just get the propellers to stay on and it was flying well and then one of the motors stop working. And on occasion the throttle will stay full blast even with the throttle stick down.

Tons of flight time. Has turtle mode and altitude hold. The rates for acro are way to high. Adjust the rates waydown and add expo. Camera and vtx are very good for a whoop. Its very stable. It has 3 modes. Stability hold, Angle and Acro. Turtle mode is nice too.

Powered on fine, bound great, but motors will not engage no matter how many different switches i try to bind to CH6.

Definitely recommend the BNF version, the controller for the ready to fly version works but is very hard to use compared to a nicer controller. The Mirarobot works very well and has a great battery life. One thing to note is that this drone will not arm unless it is on a level surface. Any sort of angle while attempting to arm for the first time after binding will cause the LED to continually cycle. However, after Arming for the first time (per battery), The drone can be disarmed and rearmed on and un-level surface (helpful when using turtle mode). Additionally, ensure that you not only bind the drone but also configure the switches for arming and flight mode using the table shown in the product pictures.The drone has decent speed for its size and adding expo is definitely recommended for acro mode. Overall I am very satisfied with the BNF version of this drone and would recommend it to anyone looking for a reliable tiny whoop. I also have a snapper 7 and I prefer this drone over it due to its ease of use. My only wish is that they would have included a USB port for config and an OSD option for battery values.

Bound it to Dx6 but motor will not throttle up. Motors don't start spinning until near the top of the throttle, and then they don't spin enough to even lift the drone.

binds pretty easy, flys good, very stable, camera weak, fpv signal average, batteries punchy, camera has bad flaw with it.