GEARit Cat6 Outdoor Ethernet Cable (50ft) 23AWG Pure Copper, FTP, LLDPE, Waterproof, Direct Burial, In-Ground, UV Resistant, POE, Network, LAN, Internet, Cat 6, Cat6 Cable - 50 Feet

Great to extend your Gen3 cable. Pure copper and 23 gauge to power the dish. I bought a 26 gauge cable previously and it would not power my dish. It rebooted constantly and never connected.The only drawbacks I’ve found is this is fairly stiff cable and the larger diameter will not fit the waterproof barrel connector I bought.

The cable was the perfect solution to get a wired network connection from my house into the workshop. The speeds across 150 have never lagged.

I used this cable to get speedy internet to the opposite end of my 126 year old wood house without using a booster. I am fortunate to have a crawl space where I can install the cable on the underside of the joists. It is very heavy duty solid copper with heavy plastic coating. I tried another cable but it quit working after a week.I got the full 1 gig speed through the cable 100' feet from my router. I got a great big hug and kiss from my wife after I used this cable to get her computer functioning again!I do recommend untwisting the cable outside to get rid of the coiling before you install it. I like the idea another user posted about leaving it in the sun for a little while to soften up the plastic sheathing making it more flexible.

I use this cable for an outdoors extender WiFi access point. A home made cable worked only for few months. This cable and connectors appears very reliable but I ca not testify of long term reliability since I am using it just since few weeks. I think is worth to try it.

Cable arrived in a few days. It was recommended by someone who wrote an article on extending your Starlink cable. I ordered the cable coupler recommended by the same writer. Both worked perfectly. Connected easily and securely. Cost is less than purchasing more Starlink product. Signal strength is great.

This 150’ cable works flawlessly with the Starlink Gen 3. This allowed us to bury the wire since we have ours on a flagpole Buddy attached to a 12’ 4x4 post with a reach of about 20 feet in the air to avoid some trees. This was a distance from our house where we have a partial sky clearing and was going to use the starlink 147’ cable but its says not to bury it because it will deteriorate in water and dirt. Just note that the cable when connected will pull out if tugged on. But if you carefully attach clips on the flagpole buddy for stress relief it will stay put. Same goes at the router end. The Starlink cable has a rubber seal that helps suction the cable into place. You also have to slide the bubble boots off, (they will slide back if you work them) to make the clearance into the slots.My suggestion do what we did use dielectric grease on the dishy side which will keep out moisture and corrosion which it why the Starlink has a rubber seal. Dielectric grease will do the same thing. Because moisture could enter. Not rain but just morning dew or humidity etc. Rain wont be an issue by design it will be humidity, so dielectric it!The cable is stiff just like coax cable. Looks like that too and about the size of RG6. It will coil just like RG6 so we just worked with it to un coil as we rolled it out then burried it. The wire jacket is a slick plastic and you can tell its made to bury.

Ordered the cable as I needed to extend the length of my Starlink cable to complete the installation of the system. It works perfectly with the Starlink system. My order was promptly shipped as well.

Used to run internet from the router in my house to my garage. It had to go through the air to a pole (secured to a 1/8" stainless wire rope to hold it up) and through 80 feet of 3/4" conduit and survived the ordeal.