Fujipoly/mod/smart Ultra Extreme XR-m Thermal Pad - 60 x 50 x 1.5 - Thermal Conductivity 17.0 W/mK

I purchased this product as I was looking for a way to keep my 3090 memory cool. I put 1mm pads on the front and 1.5mm pads on the back. I paired this with an ek water block and ek backplate for the Asus 3090 TUF. When mining Ethereum with 120 has rate, memory temps don’t go above 78c. Expensive but worth protecting such an expensive graphics card. Also, there is just enough to cover the memory so other areas of the card will need the normal EK pads.

I've been running these pads for over 6 months at this point in my 3090 Suprim X card and as you can see in the screenshot, my miner has been running straight for 26 days straight and temperatures hold solid between 76-78 at 87% fan speed. These pads are expensive but you're paying for long lasting performance that you probably won't have to replace until your next card.

Its great, very expensive but it does the job. i suggest you buy a few of the 60 x 50 1.5i highly suggest around 2 for older cards, for newer ones 3080+ i suggest you buy a bit more.

I bought this to replace the VRM Heatsink pads on a Gigabyte Aorus z370 Gaming 7 motherboard. All I had to do was cut these to fit.With a 4.7ghz overclock to an 8700k and running Prime95 Small FFT with AV2 on, the VRM’s never exceeded 65c with these pads. Beforehand the VRM’s were hitting their thermal limit after 10 minutes of testing. After a BIOS update, the board is ready for the 9900k.I’ve also used this brand on my monoblock and they work well.

Using these pads (cut to size) to repair the older HP laptops with the bad video chipsets. If there wasn't too much damage and the repair works this pad transfers the heat amazingly and keeps pressure in the chipset so it doesn't heat up and separate again. Thinking of testing on my desktop CPU, but at the price I don't want to use it needlessly as my CPU runs fine with normal thermal paste.

Extremely disappointed in these, supposedly the best thermal pads on a market cost a fortune.1- Does not compress whatsoever, if you do not measure your gaps between vram etc precisely, then expect this to cause problems with thermal paste and liquid metal between heatsink and CPU or GPU. Hard as a brick.2- Dries within minutes, apply right before connecting heatsink or else you will be picking the crusty thermal pad off of your heatsink and motherboard.3- Very expensive, for what you get. Not worth it. What a waste of money. Extortionate prices for nothing.

Great way to transfer heat away from the heatsink to the backcase. (for desk use ONLY as the bottom plate gets super hot after this mod) Idle temps on xps 13 9360 i7 8550u now in the mid to high 30s. Also repasted with Kryonaut. Laptop never sees past 80-85 now on full load of 3.2 to 3 constant. If the lame fan control in my XPS would allow for full fans i am sure I could sustain 4ghz without thermal throttling.

My 5700xt GPU mem was running to 106c gaming causing the card to throttle down, replaced with these pads and temp is at 80c max a 26c drop. The product did the job at a hefty price.