VViViD Clear Door Sill Paint Protection Anti-Scratch Film Vinyl Sheet (8" x 54")

I have little experience on installing film. The only and 1st one is install Armor Up hood guard 12"x60". Very easy to install even on small curve. This material is slightly thinner 6 mil. There are pockets generated around curved surface. My experience is to adjust the big pocket to several small pockets. See pic 1 and 3. Then use hair blower to blow the pocket to just start shrinking, follow up with tool to push the pockets away. Repeat the same step till all pockets go away. I am glad I did a good job. The only mistake is at the beginning I try to even a big pocket then cause the material wrinkled slighly.

I got this to protect my decals on my bike from dirt and rocks, I've got all the tools necessary to apply these items without issue and no matter how many times I tried, if you're doing a large area, you just end up with a bunch of bubbles. Heating the material helped a bit, but I will most likely need to redo or replace the cover because it just looks horrible with the bubbling, even when it originally laid what seemingly appeared flat.

This film is pretty rigid and reminds me more of an old school dry erase transparency sheet for a projector than PPF. The material is brittle, so it doesn't bend/form very well, but that does make it easier to cut since you can lightly score it and then just snap/pull it apart. Other films are much easier to work with and have better self healing properties. I don't think I'll buy this film again.

Had multiple spots of the film that were unusable. Still worked for my project, but had to avoid multiple spots in the roll. Also had random adhesive spots on the film I had to scratch off.

Came fast and looks exactly how it is said in the details

Works well. Used on motorcycle bodywork foe scratch protection.

The media could not be loaded.  It helps for icey soles turning yellow. This was cheaper and same quality if the rest sole protectors. Its just a car product but same material.

This stuff is very cost effective in comparison to other products. Looks like from other reviews it’s not very UV protected so if you park out side, be careful.To easy the installation, be sure to use a heat gun o around the edges!My install of 12 inch x 48 inch área took about 20 mins, use a soap solution on the paint and the adhesion side, set in place from the center then worked towards the edges.

Looks like a good product. Used it to protect the frame on my crf300l. Adhesion was good and film is decent thickness. No issues thus far. I will be using it on my other bikes too. Recommend.

Mounting system and the fuel can look solid

Worst product ever. Had no stretch to it, even on a hot sunny day. It did not even stick to my car either except for the areas that were completelyl flat. The edges were not clean cut as there were several jagged edges. The texture had the consistency of leather but was advertised as smooth and shiny. This would maybe work on a completely flat surface but if you want to put it on a curved surface, stay away!I noticed they removed another users negative review, so they must be fully aware of the garbage they are selling. I would rate it a 0 stars, but that is not possible. COMPLETE WASTE OF MONEY!Also, I contacted the company and they took so long to reply back and when they sent their final reply. They basically said I'm out of luck because I threw it out and had not documented the terrible product with photos

This was my second application after some paint work was done. I am not sure if this roll was older or beaten by the elements, but when I needed to remove it, it left a lot of the adhesive behind. The adhesive came off easy enough using the film to pull it back off as the adhesive was still tacky and not dried solid. It applies well and works, my only issue was removal.

For the price, you get what you pay for. Its ok.... not as good as premium products but the price reflects. for a cheap quick fix, it will do the job.