Hard-KOR SUPER-hard Rockwell Durometer (72d) bushings for Track
Description
This product will work in track bars built by Jeep/Mopar/Dodge, as well as many different aftermarket track bar manufacturers, so long as that bar has the "standard aftermarket track bar end-loop size", which measures 1-1/2" Inside Diameter and has a width of 1-3/16". Measure your bar to see if it will work, it fits many different aftermarket bars, as well as our Track Bar Conversion. This is perhaps the least expensive way to tighten up your steering system, removing slop, and perhaps even cure Death Wobble at the same time!
Reviews
M**N
Can definitely tell there was an improvement!
These Super Hard Bushings did make a good bit of difference compared to the red ones that come with their Adjustable Track-Bar. My case may be different than others have experienced though. Turns out the replacement/used axle I purchased is bent a little bit. Making the "Death Wobble" difficult to eliminate. Almost everything is brand new on the front end, minus shocks/springs, but still happens on occasion. No where near as bad now though!
M**O
Bad noise
They are stiffer but the creaking noise is horrible
S**E
Four Stars
Still some moment in the track bar but way better than before, Has been holding up well .
P**E
They work
They are ok. Very squeaky no matter how much grease I put on it.
C**S
Five Stars
Worked as expected
Common Questions
Trustpilot
4 days ago
1 month ago
