PME12mm 0.5" Pinstripe Pinstriping Pin Stripe Decals Vinyl Tape Stickers for Cars

Easy to apply and looks good. A low-cost way to add a nice touch.If your car is of a common color, this can make it distinct enough so you don't get in the wrong car!

I disliked how the end precies did not match up well with the original stripe.

I like that it was a value for the money and a good performing product

Quality of pin stripe is good, seems to be holding up after 2 weeks of being applied-the edges were a little hard to peel and apply w/o sticking to my fingers so I used a razor blade to try and remove the peel off plastic, overall, I'm very happy with the finished product. I did wash the bike and so far, the pinstripe is not coming off. It does tend to chip or nick very easily so be careful using anything sharp, abrasive or rubbing against the edges. Otherwise, great product and I have lots left over if I need to touch up any areas. I only used about 4 feet of tape and have plenty left.

easy to apply, looks great

Was putting this on my 20 Toyota Tacoma extra cab. Was easy to install but the roll of pin stripe was short unable to finish passenger side front corner panel see pictures advise if using buy 2 of them otherwise it will be short my was 24” short needed 36” for front corner panel .

I used these pinstripes for a nice way to trim the frosted area on my sliding shower door. The stripes peeled off easily from the roll. (I followed the trick of placing 2 small pieces of scotch tape on the end of the roll 1 piece on each side so it would stick to the tape and backing and pull them apart.) I needed to unstick and move the stripes each a few times before getting it on perfectly. I had no problems unsticking and resticking the stripes. Would definitely purchase again.

Got this for my wife’s car. I’ve installed similar tape kits on at least 8 of our vehicles over the past 20 years. The leading “arrow” trim and the back end trim do not align with the tape lines ....like they are from two different kits. Had to meticulously cut all end pieces to try to blend with the tape lines. Made in China ...maybe that’s why. Years ago, these stripe kits were made in the USA.