EVIL ENERGY 10AN Fuel Line Kit, 10AN Nylon Braided Fuel Line Hose Fitting Kit CPE 20FT BlackGlobal Recycled StandardGlobal Recycled StandardGlobal Recycled Standard

Good item! Holding up well used as transmission oil lines. Easy to assemble, quality parts.

I was initially frustrated by the outer jacket fraying during installation but this technique works great and makes these sleeved lines even easier to work with than plain old stainless lines.1. Saturate a half inch band of braid with plain super glue and let dry.2. Cut through the middle of the super glue area with a hack saw or band saw - no need to tape.3. Clean up the end with nippers. I went all the way around and made a 45 degree chamfer to make entry to the fitting easier..4. Clamp hose in vice, lube with silicon grease and drive on fitting with an impact driver and 3/4" Socket.5. Lube and screw on the end with a 3/4" flare wrench.The included fittings of nice quality.The Kit has a complete variety of fittings and is an excellent value.

Great product and great price

The product is easy to install. And it works like a champ.The only thing that the customer should know is that you don’t have the bracket in the kit that I ordered and the fitting for the inlet was too big

works great for transmission coolerlooks alot better than rubber hoses

I bought 4awg -12 I haven’t used it up yet, but my neighboring truck started installing those holes on his semi and they looked great.

Repaired leaky oil lines on my truck, cut out the old section, used Evil Energy compression fittings to adapt to AN, much higher quality and less prone to failure than the replacement parts from GM.This was my first time messing with AN stuff, but it all went really easy, the longest part of the job was getting the old stuff out of the truck. Parts are great quality, seal up nice with no leaks, easy to put together, and include a variety of fittings should you need them.Will look into Evil Energy again next time i need any fittings or line.

I used this kit to install an aftermarket transmission cooler on my truck for towing and it worked awesome. I bought some additional crush fittings to tie into the truck but this had almost everything else I needed!I cut the hose by first taping where I wanted to cut with painters tape and then using an angle grinder with cutoff wheel. This left a clean cut and I was able to easily twist the ends on with no vice needed. Just remember to twist the ends onto the hose THE OPPOSITE OF RIGHTY TIGHTY. They are reverse thread and will pull themselves onto the line by just twisting counterclockwise. Easy peezy